Peerless Industries PRG-UNV-S, PRG-UNV-W manual Installation to Concrete Ceilings

Installation to Concrete Ceilings

WARNING

•Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.

•Make sure that the wall will safely support four times the combined load of the equipment and all attached hardware and components.

3Place projector mount assembly (A) on ceiling as a template and mark the center of the two mounting holes. Drill two 5/16" (8mm) dia. holes to a minimum depth of 2-1/2" (64mm).

Attach projector mount assembly (A) using two concrete anchors (C), two fl at washers (F), and two #14 x 2-1/2" wood screws (D) as shown. NOTE: Mounting slots on projector mount assembly allow for 30° (±15°) of rotation before fully securing wood screw. Tighten wood screws (D) using 3/8" (10mm) socket wrench, phillips screwdriver or 10mm open end wrench until projector mount assembly (A) is fi rmly attached.

Skip to step 5.

CONCRETE CEILING

C

A

ARROW ON TOP OF

PROJECTOR MOUNT

ASSEMBLY INDICATES

FRONT OF MOUNT

F

D

6 of 51 ISSUED: 09-30-09 SHEET #: 056-9024-5 07-18-11