Toshiba e-STUDIO500P manual Go to StapleSmart finisher service check on

User attendance messages (continued)

Error	Sub	Primary message	Description/action
code	code
		Disk Corrupted	The printer has detected there are errors on the hard disk that cannot be
		Reformat?	corrected. The disk cannot be used until it is reformatted.
			Warning: All data on the disk will be lost if you format the disk.
			The following actions can be taken:
			•	Power off and remove the disk. The disk will not be formatted.
			•	Press	to format the disk. All data is lost when you format the disk.
		Empty Box M	This message is displayed when the hole punch alarm is on and the printer
			informed by the code the hole punch box M is full. The following actions may
			be taken:
			•	Empty the hole punch box.
			•	Press	to ignore the message. The Box M Full appears on line 2 of
				the display and the job is printed without hole punching. The message
				remains until the box is emptied.
			If this message continues to be displayed when the box has been emptied,
			go to “StapleSmart finisher service check” on page 2-123.
		Insert Box M	This message is displayed when the hole punch box is missing or installed
			incorrectly. The message is displayed during any of the following times,
			regardless of the hole punch alarm setting:
			• At POST
			•	After the finisher side door has been closed
			•	Before the first page of a job requesting hole punch. The message
				displays once per job.
			The following actions can be taken:
			•	Install the hole punch box.
			•	Press	to ignore the message. The Box M Missing message
				appears on the status line. A job that is set for hole punching will not be
				punched. The message continues to display on all subsequent jobs that
				request hole punching.
			If this message cannot be cleared after inserting the box, go to
			“StapleSmart finisher service check” on page 2-123.
		Insert Cartridge or Close	This message displays when the printer front door is open or the print
		Door	cartridge is missing.
			If this message cannot be cleared, go to “Cover closed switch/cable
			service check” on page 2-80.
		Insert Staple Cartridge	This message displays when the staple cartridge is missing or installed
			incorrectly. The message appears, regardless of the Staple Alarm setting, at
			the following times:
			• At POR
			•	After the Stapler Door has been closed.
			The following actions can be taken:
			•	Install the stapler cartridge.
			•	Press	to clear the message. The printer handles stapled jobs as if
				the staple cartridge were installed, but empty. The Staples Empty
				message appears on the status line and the Load Staples may display.

2-34Service Manual