Operation

1)Turn on the audio source (TV or audio component) to which the transmitter is connected.·

2)Switch the ON /OFF switch on the headphone to ON.

3)Place the headphones on your head and adjust the volume control to the desired listening level. The adjustable head- band lets you adjust the length of the headphones for a comfortable fit.

4)Tune the frequency adjustment control, located on the back of the transmitter, to a mid-level setting. Just rotate the thumb- wheel knob up or down and leave it set approximately in the middle of the range.

5)Adjust the tuning dial of the headphone to the frequency of the transmitter for best reception.

NOTE

You should now be able to walk freely from room to room without disruption. If disruption should occur (signal breaks up), adjust the headphones tuning control to maximize stereo reception.

If you hear interference from other components, re-adjust the twung control. Move the control on the transn1itter to a different setting, then adjust the control on the headphones to matdl the new setting. You may have to try a few loca- tions to find one with no interference.

When transn1itting/receiving over long distances, the signal from the system will become weaker and the stereo indicator light will go dinl.

For protection of the transnutter and to save power, the transnutter will cut off automatically in about one minute when the input signal from the audio source is too weak for operation. If the signal is restored, the transnutter will work

again autoinatically.