MAINTENANCE
TRACTOR
Always observe safety rules when performing any main- tenance.
BRAKE OPERATION
If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be checked and adjusted. (See “TO ADJUST BRAKE” in the Service and Adjustments section of this manual).
TIRES
•Maintain proper air pressure in all tires (See “PRODUCT SPECIFICATIONS” section of this manual).
•Keep tires free of gasoline, oil, or insect control chemi- cals which can harm rubber.
•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.
NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.
OPERATORPRESENCESYSTEMANDREVERSE OPERATION SYSTEM (ROS) (See Fig.19)
Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as described, repair the problem immediately.
•The engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disengaged position.
CHECK OPERATOR PRESENCE SYSTEM
•When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.
•When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine.
•The attachment clutch should never operate unless the operator is in the seat.
CHECK REVERSE OPERATION (ROS) SYSTEM
•When the engine is running with the ignition switch in the engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine.
•When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch en- gaged, any attempt by the operator to shift into reverse should NOT shut off the engine.
ROS "ON" POSITION | ENGINE "ON" POSITION |
| (NORMAL OPERATING) |
828
BLADE CARE(See Figs.20-22)
For best results mower blades must be kept sharp. Replace bent or damaged blades.
IMPORTANT: THE BLADES ON YOUR MOWER ARE NOT THE SAME AND MUST BE INSTALLED ON THE CORRECT SIDE. IT IS SUGGESTED THAT YOU WORK ON ONE BLADE AT A TIME TO ENSURE PROPER ASSEMBLY OF COMPONENTS.
CAUTION: Use only a replacement blade approved by the manufacturer of yourtractor.Usingabladenotapproved by the manufacturer of your tractor is hazardous, could damage your tractor and void your warranty.
02223
6 STAR PATTERN BLADE W/LEFT HAND THREADED BOLT
5 STAR PATTERN BLADE W/RIGHT HAND THREADED BOLT
FIG.20
5 STAR PATTERN BLADE
The center of this blade has a five (5) star pattern. The bolt that attaches this blade has normal Right Hand threads that loosens by turning (
) counterclockwise and tightens by turning (
) clockwise.
| TRAILING |
|
| EDGE | MANDREL |
|
| ASSEMBLY |
FLAT |
|
|
WASHER |
|
|
BLADE BOLT | RH |
|
RIGHT HAND | 5 STAR PAT- | |
THREADED | TERN |
|
| 5 STAR CEN- |
|
| TER HOLE |
|
LOCK | BLADE |
|
WASHER |
| |
FIG.21
FIG.1920