ASSEMBLY
6 | CONTAINER MOUNTING (See Fig. 6) |
No hardware required |
•Install one container to left side first with warning to outside of unit. Install other container to right side.
NOTE: Right container should always overlap left container at center support.
•Close cover and lock latch handle over center support tube.
COVER LATCH
HANDLE
CONTAINER
WARNING
CONTAINER
HANDLE
CENTER
SUPPORT
TUBE
CONTAINER
WARNING
FIG. 6
DEFLECTOR
SHIELD
7 | LOWER CHUTE (See Figs. 7A & 7B) |
Use Hardware - - GROUP "D" |
•Press weld nut into rubber latch and install two latch hook assemblies to lower chute using screw, flat washer, and lock washer as shown.
•Tighten hardware securely.
•Raise and hold deflector shield in upright position.
•Place front of chute over front of mower deck opening and slide into place as shown.
•Hook front latch down into latch hole at front of mower deck.
•Hook rear latch down into latch hole at back of mower deck.
CAUTION: Do not remove discharge guard from mower. Raise and hold guard when attaching lower chute and allow it to rest on chute while in operation.
WASHER
LOCK
WASHER
LATCH
LATCH
WELD NUT
WELD NUT | SCREW |
LOCK WASHER
WASHER
FIG. 7B
FIG. 7A
LATCH
HOOKS
9