ASSEMBLY
8 CHUTE LATCH ASSEMBLY
(See Fig. 8)
Use Hardware - - GROUPS "E & F"
•Assemble latch pin to upper chute, as shown.
•Press weld nut into rubber latch and assemble rubber latch to lower chute, as shown.
•Tighten all hardware securely.
ALIGNMENT
SLOT
LATCH PIN
#10 x
WASHERS
3/16 x 3/4 x 16 Ga.
RUBBER LATCH
| SPLIT |
| SPACER |
UPPER |
|
CHUTE | ACORN NUT |
| |
#10 x 5/8" | RUBBER |
SCREW | LATCH |
LOWER CHUTE
WELD
NUT
WASHER
3/16 x 3/4 x 16 Ga.
LOCK WASHER
FIG. 8
9 | UPPER CHUTE (See Figs. 9A & 9B) |
| |
| No hardware required |
•Lower mower deck to its lowest cutting position.
•Assemble upper chute by inserting curved end into hole in back of cover.
NOTE: Handle carefully so as not to damage dump bag indicator.
•Push in and turn upper chute until it is in line with lower chute.
•Align the bosses on lower chute with alignment slots on upper chute and slide together.
•Secure with rubber latch by hooking hole in latch over
BOSSES
FIG. 9B
10 LEVEL MOWER DECK No hardware required
•Be sure deck is properly leveled for best mower perfor- mance. See your tractors owner's manual for instruc- tions.
latch pin.
COVER
HANDLE
UPPER
CHUTE
LOWER CHUTE
10