ASSEMBLY
7 CONTAINER MOUNTING (See Fig. 7)
No hardware required
•Install one container to left side first with warning to outside of unit. Install other container to right side.
NOTE: Right container should always overlap left container at center support.
•Close cover and lock latch handle over center support tube.
COVER LATCH
HANDLE
CONTAINER
WARNING
G NI N | RAW |
|
ARNING
CONTAINER
HANDLE
CENTER
SUPPORT
TUBE
CONTAINER
WARNING
FIG. 7
8 | LOWER CHUTE (See Figs. 8A & 8B) |
Use Hardware - - GROUP "E" |
•Press weld nut into rubber latch and install two latch hook assemblies to lower chute using screw, washer, and lock washer as shown.
•Tighten hardware securely.
•Raise and hold deflector shield in upright position.
•Place front of chute over front of mower deck opening and slide into place, as shown.
•Hook front latch into latch bolt on front of mower deck.
•Hook rear latch into latch bolt on back of mower deck.
CAUTION: Do not remove discharge guard from mower. Raise and hold guard when attaching lower chute and allow it to rest on chute while in operation.
| WASHER | |
| WASHER | |
LOCK | LOCK WASHER | |
WASHER |
| |
| LATCH | |
LATCH | WELD | |
| ||
| NUT | |
WELD | SCREW | |
NUT | ||
| ||
| FIG. 8A | |
| DEFLECTOR | |
| SHIELD |
LATCH
HOOKS
FIG. 8B
9 CHUTE LATCH ASSEMBLY
(See Fig. 9)
Use Hardware - - GROUPS "F & G"
•Assemble latch pin to upper chute, as shown.
•Press weld nut into rubber latch and assemble rubber latch to lower chute, as shown.
•Tighten all hardware securely.
| WASHERS | |
#10 X | 3/16 X 3/4 X 16 | |
GA. | ||
| ||
| SPLIT | |
| SPACER | |
UPPER CHUTE |
| |
| ACORN NUT | |
#10 X 5/8" |
| |
SCREW | RUBBER | |
| LATCH | |
LOWER CHUTE |
| |
| WELD | |
| NUT |
WASHER
3/16 X 3/4 X 16 GA.
LOCK WASHER
FIG. 9
9