FUEL HANDLING
Fuelmix
IMPORTANT! The machine is equipped with a
!Always provide for good ventilation when handling fuel.
Petrol
Fuelling
!WARNING!The following precautions reduce the risk of fire:
•Do not smoke or place any sources of heat in the vicinity of the fuel.
•Never refuel when the engine is running.
•Open the fuel cap slowly when fuelling so that any over pressure is released slowly.
•Tighten the fuel cap carefully after refuelling.
•Always move the machine from the fuelling place before starting.
•Use good quality unleaded or leaded petrol.
•The lowest octane recommended is 90 (RON). If you run the engine on a
lower octane grade than 90
Two-stroke oil
•For best results and performance use HUSQVARNA
formulated for our
• Never use
• Never use oil intended for
Mixing ratio
1:50 (2%) with HUSQVARNA
Mixing
• Always mix the petrol and oil in a clean container intended for fuel.
• Always start by filling half the amount of the petrol to be used. Then add the entire amount of oil. Mix (shake) the fuel mixture. Add the remaining amount of petrol.
• Mix (shake) the fuel mixture thoroughly before filling the saw’s fuel tank.
•Do not mix more than max. one month’s supply of fuel.
•If the
•Keep the handle dry, clean and free from oil and fuel.
•Clean around the fuel cap. Clean the fuel tank regularly. The fuel filter should be changed at least once per year Contamination in the tank can disrupt operations. Ensure that the fuel is well mixed by shaking the container before filling the tank.
•Always exercise care when filling the fuel. Move the cut- off saw at least three metres from the filling area before starting. Make sure the fuel cap is tightened.
Min 3 m |
(10ft) |
English – 15 |