Husqvarna 61, 268 manual Throttle lock

Page 9

SAFETY INSTRUCTIONS

2 Throttle lock

1Make sure the throttle control is locked at the idle setting when you release the throttle lock.

2Press the throttle lock and make sure it returns to its original position when you release it.

3Check that the throttle control and throttle lock move freely and that the return springs work properly.

4Start the saw and apply full throttle. Release the throttle control and check that the chain stops and remains stationary. If the chain rotates when the throttle is on idle setting you should check the carburettor idle adjustment. See the section on ”Maintenance”.

3 Chain catcher

Check that the CHAIN CATCHER is not damaged and is firmly attached to the body of the saw.

4 Right hand guard

Check that the right hand guard is not damaged and that there are no visible defects, such as cracks.

5 Vibration damping system

Regularly check the vibration damping units for cracks or deformation

Make sure the vibration damping units are securely attached to the engine unit and handles.

6 Stop switch

Start the engine and make sure the engine stops when you move the stop switch to the stop setting.

English – 9

Image 9

Contents English Operator´s manualKEY to Symbols Symbols on the chain sawSymbols in the operator’s manual Contents Personal Protective Equipment Safety Instructions3a Starting Chain brake and front hand guardThrottle lock Chain catcherRight hand guard Stop switch Vibration damping systemMuffler Checking the front hand guard Checking brake band wearChecking the inertia brake release Checking the brake triggerThrottle lock 5 basic rules Cutting EquipmentBar Cutting equipment designed to minimise kickbackSaw chain Some terms that describe the bar and chainSharpening your chain and adjusting raker clearance General information on sharpening cutting teethSharpening cutting teeth General advice on setting raker clearance Setting the raker clearanceTensioning the chain Lubricating cutting equipment Chain oilFilling with chain oil Lubricating the clutch drum bearing Checking chain lubricationChecking wear on cutting equipment Lubricating the bar tip sprocketWhat is kickback? HOW to Avoid KickbackDo not let go of the handles General rulesGeneral Safety Precautions Basic safety rules Min m10 ft General Basic cutting techniqueTerms CuttingSafe distance Tree felling techniqueLimbing Felling directionFelling Clearing the trunk and preparing your retreatCutting the trunk into logs Freeing a tree that has fallen badly = high accident riskFreeing a Trapped tree Cutting trees and branches that are in tension PreparationsWhat is WHAT? Assembly Mounting guide bar and chainFitting a spike bumper Fuelmix Fuel HandlingFuelling Min 3 m10ft Start Start and StopCold engine Warm engineCarburettor MaintenanceStarter device Starter device assemblyChanging a broken or worn starter cord Tensioning the recoil springAir filter Adjusting the oil pumpSpark plug MufflerTemperature 0oC 32oF or colder Needle bearing maintenanceTemperature -5oC 23oF or colder Cooling systemMonthly maintenance Weekly maintenance Daily maintenanceTechnical Data 268Bar and chain combinations EC-declaration of conformity Applies to Europe only 2002W02 114 00