Husqvarna 61, 268, 272XP manual Chain brake and front hand guard

Page 5

SAFETY INSTRUCTIONS

1 Chain brake and front hand guard

YOUR chain saw is equipped with a chain brake that is desig- ned to stop the chain immediately if you get a kickback.

The chain brake reduces the risk of accidents, but only You can prevent them.

Take care when using your saw and make sure the kickback zone of the bar never touches any object.

2 The front hand guard is

not designed solely to

activate the chain brake.

Another important safety

feature is that it prevents

the chain from hitting your

left hand if you lose your

grip on the front handle.

3 You can also use the

chain brake as a

1The chain brake (A) can either be activated manually (by your left hand) or automatically by the inertia release mechanism (a free- swinging pendulum). On most of our models the front hand guard acts as a counterweight in case of kickback.

The brake is applied when the front hand guard (B) is pushed forwards.

This movement activates

aspring-loaded mechanism that tightens the Brake Band (C) around the engine drive system (D) (Clutch Drum).

B

A

B

B

C

D

temporary brake when you

change position or if you

put the saw down for a

short time. You should

also apply the chain brake

manually if there is a risk

of the chain accidentally

hitting anyone or anything

close by.

4To release the chain brake pull the front hand guard backwards, towards the front handle.

5As mentioned in section A, kickback can be very sudden and violent.

Most kickbacks are minor and do not always activate the chain brake. If this happens you should hold the chain saw firmly and not let go.

English – 5

Image 5

Contents 101 91 61/268/272XPSymbols in the operator’s manual KEY to SymbolsSymbols on the chain saw Contents Personal Protective Equipment Safety InstructionsChain brake and front hand guard Right hand guard Throttle lockChain catcher Muffler Stop switchVibration damping system Checking the front hand guard Checking brake band wearChecking the inertia brake release Checking the brake triggerThrottle lock 5 basic rules Cutting EquipmentBar Cutting equipment designed to minimise kickbackSaw chain Some terms that describe the bar and chainSharpening cutting teeth Sharpening your chain and adjusting raker clearanceGeneral information on sharpening cutting teeth Tensioning the chain General advice on setting raker clearanceSetting the raker clearance Filling with chain oil Lubricating cutting equipmentChain oil Lubricating the clutch drum bearing Checking chain lubricationChecking wear on cutting equipment Lubricating the bar tip sprocketWhat is kickback? HOW to Avoid KickbackDo not let go of the handles General rules10 ft Min mGeneral Working Instructions Basic safety rulesGeneral Basic cutting techniqueTerms CuttingSafe distance Tree felling techniqueLimbing Felling directionFelling Clearing the trunk and preparing your retreatCutting the trunk into logs Freeing a tree that has fallen badly = high accident riskFreeing a Trapped tree Cutting trees and branches that are in tension PreparationsWhat is WHAT? Fitting a spike bumper AssemblyMounting guide bar and chain Fuelmix Fuel Handling10ft FuellingMin 3 m Start Start and StopCold engine Warm engineCarburettor MaintenanceStarter device Starter device assemblyChanging a broken or worn starter cord Tensioning the recoil springAir filter Adjusting the oil pumpSpark plug MufflerTemperature 0oC 32oF or colder Needle bearing maintenance Winter useTemperature -5oC 23oF or colder Cooling systemMonthly maintenance Weekly maintenance Daily maintenanceBar and chain combinations Technical Data268 272XP EU declaration of conformity Only applies to Europe English 38´*33¶6\¨ English ´*33¶6\¨