Jensen CM715K specifications Tools and Supplies Needed, Prepare Radio for Installation

®

CM715K

Installation

Before You Begin Installation

Before you begin, you will need tools, supplies and adapters. It is best to make sure you have everything you need before you take your dashboard apart.

Tools and Supplies Needed

Basic Installation:

•Flat and Phillips screwdrivers

•Wire cutters

•Wire strippers

•Tools to remove existing radio (screw- driver, socket wrench set or other tools)

•Electrical tape

Advanced Installation:

•Soldering iron

•Crimping tool

•12 volt test light / Digital Meter

•Solder

•Crimp connectors

•18 gauge wire for power connections

•Speaker wire

Prepare Radio for Installation

Remove transport screws (you cannot insert a CD until the screws are removed)

PWR
	CM715K
A.PS DISC				INSTALOC II		TUNER
								CDC	CONTROLLER
SEL
VOL
			4								CD
				X 50W	CD/CASSETTE
		DISP									TAPE
VOL	1 SCN		LOUD
										PROG
		2 RPT				MUTE
			3 A-B								BAND
			RPT		4 RDM
						5
							PGM		MEM
									6 CLR	MO	CDC

Put adhesive dots (from accessory kit) over transport screw holes

Adapters for Easier Installation

Speaker Requirements

Only connect the CM715K to speakers rated in the load impedance range of 4 to 8 ohms. Speakers with a load impedance less than 4 ohms could damage the CM715K.

Electrical and dashboard adapters make installation easier. Purchase adapters from your local Jensen retailer, electronics store or car stereo specialty store.

Wiring Harness Adapter

For a basic installation, you can purchase a wiring harness adapter for your car's existing radio connectors. This makes installation easy.

Antenna Adapter (GM cars)

1990 and newer GM cars have a small antenna connector. You will need an adapter when installing this radio in a newer GM car.

2

Untitled-3 2 4/10/99, 7:38 PM