Hustler Turf 50 owner manual Electrical Engine wiring, Grass catcher

when the traction drive is engaged.

E.Brake lever (Fig. 3-1 & Fig. 3-2) — The brake lever is mounted off the LH operator handle. This brake has two levers. The longer lever is pulled to engage the brake. To set the park brake, pull this long lever back toward the handlebar until the park brake lever snaps into the locked

position. Release the long brake lever, and the park brake is set. To release the park brake, pull on the shorter park brake lever and the long brake lever returns to the released position

F.Choke control (Fig. 3-3) — The choke is controlled directly on the engine. As the decal indicates, the choke is on when the lever is pushed to the forward direction of the machine, and off when the lever is pulled to the rear. Choke should only be used when starting the engine, and shall remain off when in normal operation.

G.Fuel valve (Fig. 3-3) — Push fuel valve lever forward to open fuel valve and push lever rearward to shut fuel valve off. IMPORTANT: Fuel valve should be shut off when engine is not running and machine is stopped.

C

D

AB

G Fuel valve shown in “OFF” position

F Choke shown in “OFF” position

Fig. 3-3

used and shall remain unplugged.

C.Engine coil kill wire (Fig. 3-4)

D.Ignition switch wire (Fig. 3-4) — This single green wire connects to the ignition switch located at the operator handlebars. It is to remain plugged into the female bullet connector from engine coil kill wire at all times.

E.Braided wire loom - optional light power (Fig. 3-4) — These wires provide power to the optional light kit. Leave bundled with the tape in place if light kit is not installed.

E

Fig. 3-1

E

B

A

D

C

E

Park brake lever

Fig. 3-2

Electrical - Engine wiring

A.Engine switch (Fig. 3-4) — There is an “ON - OFF” switch located on the front of the engine. This switch is not used and shall remain in the off position.

B.Wire lead - engine switch (Fig. 3-4) — This wire is not

Fig. 3-4

Grass catcher

When attaching the grass catcher make sure that the catcher’s mounting pins are seated firmly in place on the mower. Make sure that it is down in the positioning slots as far as it will go and is not sitting at an angle. Fig. 3-5 & Fig. 3-6

WARNING: Attach the grass catcher prior to starting the engine to prevent injury. Grass catcher should be attached to machine at all times when in operation!

111132_0409 3-3