Husqvarna Comprehensive Guide for Belt Replacement and Adjustment on Tillers

 Page 16

SERVICE AND ADJUSTMENTS

TO REPLACE GROUND DRIVE BELT (See Figs. 25 and 26)

•Remove belt guard as described in “TO REMOVE BELT GUARD”.

•Remove old belt by slipping off engine pulley first then remove from transmission pulley.

•Place new belt in groove of transmission pulley and into engine pulley. BELT MUST BE IN GROOVE ON TOP OF IDLER PULLEY. NOTE POSITION OF BELT TO GUIDES.

•Check belt adjustment as described below.

•Replace belt guard.

•Reposition wheel and replace clevis pin and hairpin clip.

GROUND DRIVE BELT ADJUSTMENT (See Fig. 26)

For proper belt tension, the extension spring should have about 5/8 inch (16 mm) stretch when drive control bar is in “ENGAGED” position. This tension can be attained as follows:

•Loosen cable clip screw securing the drive control cable.

•Slide cable forward for less tension and rearward for more tension until about 5/8 inch (16 mm) stretch is obtained while the drive control bar is engaged.

•Tighten cable clip screw securely.

CABLE CLIP SCREW

ENGINE

PULLEYDRIVE CONTROL CABLE

LESS

TENSION

 

 

MORE

5/8"

 

TENSION

EXTENSION

IDLERSPRING

PULLEYTRANSMISSION

PULLEY

FIG. 26

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents
DRT Safety Rules Maintenance and StorageTraining PreparationTable of Contents Tools Required for Assembly AssemblyOPERATOR’S Position See Fig Install Handle See Figs , 4, Unpacking Carton See FigAttach Clutch Cable See Fig Connect Shift ROD See FigRemove Tiller from Crate Check Tire PressureOperation Meets Ansi Safety RequirementsKnow Your Tiller HOW to USE Your Tiller Tine Operation with Wheel DriveForward Wheels ONLY/TINES Stopped Reverse Wheels ONLY/TINES StoppedTurning CultivatingTo Transport Before Starting EngineTo Start Engine See Fig ADD GasolineTilling Hints See Fig Adjust Wheels for Cultivating See Figs Maintenance Maintenance ScheduleGeneral Recommendations Lubrication Chart Before Each USEEngine AIR Filter See FigCleaning Cooling System See FigMuffler Spark PlugTiller Service and AdjustmentsTire Care Ground Drive Belt Adjustment See Fig To Replace Ground Drive Belt See FigsTine Replacement See Figs , 28 To Adjust Throttle Control Cable See Fig To Adjust CarburetorStorage OtherFuel System Engine OILTroubleshooting Points Repair Parts Handle AssemblyMAINFRAME, Left Side MAINFRAME, Right Side KEY Part NO. NO. Description   Tine Shield Tine Assembly Decals 11.15.10 SR
Related manuals
Manual 28 pages 4.96 Kb