Husqvarna 326C Cooling system, Spark plug, Two-piece shaft, Air filter, Cleaning the air filter

Page 21

MAINTENANCE

Cooling system

To keep the working temperature as low as possible the machine is equipped with a cooling system.

4

3

2

1

The cooling system consists of:

1Air intake on the starter.

2Fins on the flywheel.

3Cooling fins on the cylinder.

4Cylinder cover (directs cold air over the cylinder).

Clean the cooling system with a brush once a week, more often in demanding conditions. A dirty or blocked cooling system results in the machine overheating which causes damage to the piston and cylinder.

Spark plug

The spark plug condition is influenced by:

Incorrect carburetor adjustment.

An incorrect fuel mixture (too much or incorrect type of oil).

A dirty air filter.

These factors cause deposits on the spark plug electrodes, which may result in operating problems and starting difficulties.

If the machine is low on power, difficult to start or runs poorly at idle speed: always check the spark plug first before taking any further action. If the spark plug is dirty, clean it and check that the electrode gap is 0.5 mm (0,020"). The spark plug should be replaced after about a month in operation or earlier if necessary.

CAUTION! Always use the recommended spark plug type! Use of the wrong spark plug can damage the piston/cylinder. Check that the spark plug is fitted with a suppressor.

Two-piece shaft

(326LDx)

The drive shaft end in the lower shaft should be lubricated with grease every 30 hours. There is a risk that the drive shaft ends (splined coupling) on models with two-piece shafts will seize if they are not lubricated regularly.

Air filter

The air filter must be regularly cleaned to remove dust and dirt in order to avoid:

Carburettor malfunctions

Starting problems

Loss of engine power

Unnecessary wear to engine parts

Excessive fuel consumption.

Clean the filter every 25 hours, or more regularly if conditions are exceptionally dusty.

Cleaning the air filter

Remove the air filter cover and take out the filter. Wash it clean in warm, soapy water. Ensure that the filter is dry before refitting it.

An air filter that has been in use for a long time cannot be cleaned completely. The filter must therefore be replaced with a new one at regular intervals. A damaged air filter must always be replaced.

If the machine is used in dusty conditions the air filter should be soaked in oil. See instructions under the heading Oiling the air filter.

English – 21

Image 21
Contents 326C 326L 326LX-SERIES Symbols KEY to SymbolsContents Dear customer IntroductionWhat is what? What is WHAT?General Safety Precautions Machine′s safety equipmentPersonal protective equipment Stop switch Throttle lockCutting attachment guard Muffler Vibration damping systemCutting equipment Locking nutTrimmer head Assembly AssemblyFitting the loop handle Assembling and dismantling the two-piece shaftFitting other guards and cutting attachments Fitting the trimmer headGuard Fitting the trimmer guard and trimmer headFuel safety Fuel HandlingFuel Mixing FuelingCheck before starting Starting and StoppingStarting and stopping StartingStopping Working Techniques Basic safety rulesGeneral working instructions Basic working techniques Clearing Carburetor MaintenanceCorrectly adjusted carburetor Fine adjustment of the idle speed TMuffler High speed jet HCooling system Cleaning the air filterSpark plug Two-piece shaftBevel gear Oiling the air filterMaintenance Maintenance scheduleTechnical data Technical DataAttachments Art No Use with Your Warranty Rights and Obligations Federal Emission Control Warranty StatementTrimmy Hit Junior Trimmy T25 T25C 2,4 mm 079-0.095 75 m x Clic Trimmy H Click Trimmy Hit Pro Super Auto Super Auto II S35 25 m ´z+HAo¶5¨ T35 1140337-95 ´z+HAo¶5¨ ´z+HAo¶5¨