Image IMSB73911, IMSG73911 user manual Symptom the Water Level Drops

Page 17

9.SYMPTOM: THE WATER LEVEL DROPS

a.A clamp or seal inside the pump compartment may be loose. Check inside the pump compart- ment for excess water and watch the pump unit while it is operating to see if water drips from any of the plumbing. If you can identify the location of the leak inside the spa jet unit, tight- en the clamp or replace the damaged seal.

b.Some water loss due to evaporation is normal. If rapid water loss occurs, or if you notice wet- ness on the floor around the hydrotherapy spa, the spa shell may have a leak. Contact your local pool and spa service provider for repairs.

10.SYMPTOM: THE SPA JET UNIT CONTINUES TO RUN AFTER IT HAS BEEN SHUT OFF

a.To turn the main jets off, press pump button 1 once or twice. Note: If the actual spa water temperature is below the set temperature, or if the spa is running a filter cycle, the heater pump/motor will not shut off.

17

Image 17
Contents Customer HOT Line Model No. IMSB73911 IMSG73911 Serial NoPosting the Warning Sign Table of ContentsRead and Follow ALL Instructions Important Safety InstructionsPage Page Before You Begin Choosing a Location for the Hydrotherapy Spa If you set up the hydrotherapy spa insideIf you set up the hydrotherapy spa outside Assembly For use sooner. Do not overfill the spa Wiring the Hydrotherapy SPA Using the Hydrotherapy SpaTesting and Treating the Water Securing the SPA Cover on the SPAK M GK E Spa Shell DiagramUsing the Controls Maintenance Maintaining the Proper PH Balance Attaching and Removing the Access PanelSanitizing the Hydrotherapy SPA Changing the Filter CycleReplacing the Light Bulb Draining the PumpsTroubleshooting Symptom the Water Level Drops Key No. Qty Description Part List-Model No. IMSB73911/IMSG73911 R0302AExploded Drawing-Model No. IMSB73911/IMSG73911 R0302A Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty