Image IMSB73911, IMSG73911 user manual For use sooner. Do not overfill the spa

3.Insert the pillow (47) into the lounge seat receptacle. The pillow can be rotated 180° to change between the high and low positions.

3 47

4. The hydrotherapy spa operates on a 240 volt power source and must be wired directly to a 40 amp, Ground
Fault Circuit Interrupter (GFCI)-protected circuit breaker installed in your home. This must be performed by a
qualified, licensed electrician. A wiring diagram is found on the inside of the electronics package for
reference. Under no circumstance should the spa be wired by someone other than a qualified electri-
cian. Before you have the spa wired, make sure it is in the desired position, and that it can be easily serviced.
5. Make sure that a qualified electrician has wired the	5	3
spa to a 240 volt power source.
Remove the two warning decals (see page 5) from		Fill to Here
the spa shell. Using a damp cloth, wipe the spa shell
clean. Before filling the spa, make sure that it is		5
in the desired position and that there is room to
easily service it. Once the spa is filled, it will
have to be drained before it can be moved.
Insert a garden hose into a filter housing and fill the		Filter Housing
spa to the level shown at the right. Do not use soft
water. The spa may be filled with cold water; howev-
er, if warm or hot water is used, the spa will be ready
for use sooner. Do not overfill the spa.
Refer to the inset drawing. Set the Filters (5) into the
filter housings. Next, screw the Filter Covers (3) into		Garden Hose
the filter housings until they are fully seated.
6. Pull down one of the straps on the Spa Cover (11)	6
and hold the Buckle (26) against one of the premium
		Strap
cedar panels on the spa. (Note: To position the
		11
Buckle correctly, have a second person hold the		Latch
strap on the opposite side of the Spa Cover snug.)
The Spa Cover must be snug. Do not place the		26
Buckle over the grooves between the premium
cedar panels. Refer to the inset drawing. Remove
the latch from the Buckle (26). Attach the Buckle to
the premium cedar panel with two #4 x 3/4” Screws		27
(27).
Attach the other three Buckles (26) to the premium		Strap
cedar panels in the same way.
Remove the Spa Cover (11) from the spa.		26

9