ERROR CODES and DISPLAY INDICATORS
Error | Error | Possible | |
Code | Description | Causes | |
Err1 | The high limit temperature sensor | • | Inadequate ventilation. |
| has tripped. | • | Room fan failure. |
|
| • | Exhaust Blockage. |
|
| • Electrical Open in the over temperature switch or wiring. | |
Err2 | The low limit temperature sensor | • | Hopper Empty. |
| has tripped. | • Auger output failure or jam. | |
|
| • Poor flame or fuel quality caused fire to burn too slowly or go out. | |
|
| • Electrical Open in low temperature switch or wiring. | |
|
| • Fire was not well established before the PCB’s programmed time | |
|
| limit expired. | |
Err3 | The heater was unable to reach the | • Poor flame or fuel quality caused fire to burn too slowly or go out. | |
| Room Fan On temperature within the | • | Auger output failure or jam Hopper empty on startup. |
| startup time. |
|
|
Err4 | The power failed while the heater | • Electrical Open in low temperature switch or wiring. | |
| was hot, and when power was re- | • | Power loss |
| stored, the fire was out. |
|
|
Err5 | The Auger output fuse has blown. | • Auger motor jammed or bad. | |
Err6 | The Agitator output fuse has blown. | • Agitator motor jammed or bad. | |
Err7 | The Draft Fan (Exhaust Fan) output | • Draft Fan motor jammed or bad. | |
| fuse has blown. |
|
|
Err8 | The Room Fan output fuse has | • Room fan motor jammed or bad. | |
| blown. |
|
|
Err9 | Zero Crossing Input failed | • AC supply frequency out of range. | |
Err10 | The Igniter output fuse has blown | • Igniter output has shorted/blown or igniter overload. | |
Display Indicators
Several situations or events are indicated in normal operation by blinking display indicators or segments in the display: Flashing On Indicator: This means that the heater is in the “Start Up” awaiting for the ignition procedure to complete.
Flashing Off Indicator: This indicates that the heater is in the “Shutdown” state waiting for the OFF button, or for a 15 minute period after the heater was turned off, or for the heater to cool down, or for the door to be closed.
Flashing dash in Heat Range Display: This indicates that the heater is in the normal run mode and is ramping from the current heat range setting to the target heat range setting. Once the ramp is complete, the dash will stop flashing. For ramping from heat range 1 to 5, the default time is 12 minutes (with a 90 second ramp time).
Flashing heat range value in “Heat Range” display: For example, if the display is showing
Flashing Automatic Mode Indicator: This indicates that the heater is in normal operation and is running in the automatic mode. However, either the Draft Fan or Auxiliary setting is manually configured.
Flashing Draft Fan Setting Indicator: This indicates that the heater is in normal operation and that the vacuum sensor detects a loss of pressure either because the door is open or because there is a negative pressure in the room with respect to the exhaust.
Flashing Aux Indicator: This indicates that the igniter is on during the lighting stage.
Quick (changes twice per second) Flashing Heat Range Setting Indicator : This indicates that the heater is in normal operation and that an over temperature condition exists causing the fuel to stop.
Slow (changes once per second) Flashing Heat Range Setting Indicator : This indicates that the heater is in a cutback condition in an attempt to prevent an over temperature shutdown.
Factory Defaults
To return the control to its original factory default settings, press and hold the AUX UP and AUX DOWN buttons together for three seconds.
USSC | 23 |