Ryobi Outdoor RY30130 Starting and Stopping, See Figures 5, To Start a Cold Engine, Start Lever

Page 11

OPERATION

STARTING AND STOPPING

See Figures 5 - 7.

TO START A COLD ENGINE:

DO NOT squeeze the throttle trigger until the engine starts and runs.

Lay the trimmer on a flat, bare surface.

PRIME - Press the primer bulb 7 times.

SET the start lever to the START position.

PULL the rope until the engine starts.

Wait 6-10 seconds, then squeeze the trigger to run.

NOTE: Squeezing the throttle trigger releases the start lever to the RUN position.

TO START A WARM ENGINE: PULL the rope until the engine starts.

TO STOP THE ENGINE:

Press and hold the switch in the stop “ ” position until the engine stops.

IGNITION

SWITCH

TRIGGER

LOCK

THROTTLE

TRIGGER

Fig. 5

PRIMER BULB

IGNITION

SWITCH

TRIGGER LOCK

THROTTLE TRIGGER

Fig. 6

START POSITION

START LEVER

RUN POSITION

START LEVER

Fig. 7

Image 11

Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction Table of ContentsRead ALL Instructions General Safety RulesSpecific Safety Rules for Edger USE Specific Safety RulesSpecific Safety Rules for Trimmer USE Symbol Name Explanation SymbolsSymbol Signal Meaning ServiceBlade Debris Flap Gear Head Wheel Starter Grip Rope Rear HandleCoupler Knob Blade Guard Primer Bulb END CAPAssembly FeaturesAttaching the Front Handle to the Power Head Shaft Installing AN Attachment to the Power HeadRemoving AN Attachment from the Power Head Fueling and Refueling the Trimmer OperationAttaching the Grass Deflector To Stop the Engine Starting and StoppingSee Figures 5 To Start a Cold EngineLine Trimming CUT-OFF Blade Advancing Trimmer Cutting LineGrass Deflector Line Trimming CUT-OFF Blade Operating the TrimmerSee Figures 9 Trimmer Cutting TipsOperating the Edger Edger Cutting TipsSee Figures 12 MaintenanceAdjusting Edger Blade Depth General MaintenanceSpool Retainer Spring Slots Eyelets String Head Shaft NEW Prewound SpoolSee Figures 14 First String Slot String ReplacementSee Figures 16 Arrows on Spool Anchor HoleSpark Arrestor Cleaning the Exhaust Port and MufflerReplacing and Cleaning AIR Filter Spark Plug ReplacementBlade NUT Holding PIN Socket Wrench Edger Blade ReplacementSee Figures 21 Upper Flange Washer Gear Case Lower Flange WasherAttaching the Storage Hanger Debris Flap ReplacementStorage 1 Month or Longer Idle Speed Screw TroubleshootingSpeed. See Figure This Product WAS Manufactured with a Catalyst Muffler WarrantyLimited Warranty Statement Coverage MANUFACTURER’S Warranty CoverageOWNER’S Warranty Responsibilities Maintenance RequirementsService