Ryobi Outdoor RY30130, RY30120 manual Debris Flap Replacement, Storage 1 Month or Longer

Page 19

MAINTENANCE

DEBRIS FLAP REPLACEMENT

See Figure 25.

Replace the debris flap if it is worn.

Using a 10 mm wrench or socket, remove the retaining nuts, washers, and debris flap.

Install the new debris flap. This replacement part is avail- able from the place of purchase, or by calling 1-800-242- 4672.

Replace retaining nuts and washers.

Tighten securely.

STORAGE (1 MONTH OR LONGER)

Drain all fuel from tank into a container approved for gasoline. Run engine until it stops.

Abide by all ISO and local regulations for the safe storage and handling of gasoline. Excess fuel should be used up in other 2-cycle engine powered equipment.

Clean all foreign material from attachments. Do not grasp exposed cutting blades when picking up or holding the attachments.

Store idle unit indoors in a dry, well-ventilated area that is inaccessible to children. Keep away from corrosive agents such as garden chemicals and de-icing salts.

ATTACHING THE STORAGE HANGER

See Figure 26.

There are two ways to hang the attachment for storage.

To use the hanger cap, push in the button and place the hanger cap over end of the lower end of attachment shaft. Slightly rotate the cap from side to side until the button locks into place.

The secondary hole in the attachment shaft can be used for hanging purposes as well.

RETAINING NUTS

EDGER GUARD

 

WASHERS

DEBRIS FLAP

Fig. 25

HANGER

CAP

HOLE

SECONDARY

HOLE

BUTTON

Fig. 26

19

Image 19
Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction Table of ContentsRead ALL Instructions General Safety RulesSpecific Safety Rules for Trimmer USE Specific Safety RulesSpecific Safety Rules for Edger USE Symbol Name Explanation SymbolsSymbol Signal Meaning ServiceBlade Debris Flap Gear Head Wheel Starter Grip Rope Rear HandleCoupler Knob Blade Guard Primer Bulb END CAPAssembly FeaturesRemoving AN Attachment from the Power Head Installing AN Attachment to the Power HeadAttaching the Front Handle to the Power Head Shaft Attaching the Grass Deflector OperationFueling and Refueling the Trimmer To Stop the Engine Starting and StoppingSee Figures 5 To Start a Cold EngineLine Trimming CUT-OFF Blade Advancing Trimmer Cutting LineGrass Deflector Line Trimming CUT-OFF Blade Operating the TrimmerSee Figures 9 Trimmer Cutting TipsOperating the Edger Edger Cutting TipsSee Figures 12 MaintenanceAdjusting Edger Blade Depth General MaintenanceSee Figures 14 NEW Prewound SpoolSpool Retainer Spring Slots Eyelets String Head Shaft First String Slot String ReplacementSee Figures 16 Arrows on Spool Anchor HoleSpark Arrestor Cleaning the Exhaust Port and MufflerReplacing and Cleaning AIR Filter Spark Plug ReplacementBlade NUT Holding PIN Socket Wrench Edger Blade ReplacementSee Figures 21 Upper Flange Washer Gear Case Lower Flange WasherStorage 1 Month or Longer Debris Flap ReplacementAttaching the Storage Hanger Speed. See Figure TroubleshootingIdle Speed Screw This Product WAS Manufactured with a Catalyst Muffler WarrantyLimited Warranty Statement Coverage MANUFACTURER’S Warranty CoverageOWNER’S Warranty Responsibilities Maintenance RequirementsService