Ryobi PBC3046B, RY70107 manual Blade Guard, Grass Deflector, Converting from Trimmer to Brushcutter

Page 9

ASSEMBLY

BLADE GUARD

See Figure 6.

1.Attach the blade guard to the mounting bracket; install the four screws (10-24 x 3/4 in) from the top of the mounting bracket through the blade guard and into the threaded mounting plates.

2.Using the torque wrench supplied, tighten all four screws securely.

NOTE: When using the string head, the string shield must be attached to blade guard.

GRASS DEFLECTOR

See Figure 6.

1.Attach the grass deflector to the blade guard by placing the three locking tabs into the three notches.

2.Snap the blade guard and grass deflector together to lock into place.

FOUR SCREWS

MOUNTING CLAMP

BLADE GUARD

NOTCHES

LOCKING

TABS

THREADED

MOUNTING PLATES

WARNING:

Always stop the engine and remove the sparking plug wire before making any adjustments such as changing cutting heads; this is to reduce the risk of serious personal injury.

CONVERTING FROM TRIMMER TO

BRUSHCUTTER

REMOVING THE STRING HEAD

See Figure 7.

1.Align the slot in the upper flange washer with the hole in the gear head. Place the holding pin through the slot in the upper flange washer and the hole in the gear head.

Turn the spool retainer clockwise to remove. Remove the spool and string head from the drive connector.

2.Place the holding pin through the upper flange washer and the gear head. Using the 16 mm (5/8 in) spanner supplied, turn the drive connector clockwise to remove.

3.Remove the upper flange washer from the gear shaft and retain for blade installation.

4.Remove the grass deflector by pushing in on the three locking tabs while pulling on the grass deflector to separate from the blade guard.

NOTE: Store the string head parts together for later use.

UPPER FLANGE

WASHER

HOLDING PIN

STRING HEAD

GRASS DEFLECTOR

Fig. 6

GRASS

DEFLECTOR

SPANNER

(16 mm)

DRIVE CONNECTOR

SPOOL RETAINER

Fig. 7

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents OPERATOR’S Manual Safety Table of ContentsSpecific Safety Rules for Brushcutter and Blade USE Specific Safety Rules for Trimmer USESymbol Name Explanation SymbolsSymbol Name Technical DataUnpacking FeaturesInstructions Packing List for OWNER’S KITHandle AssemblySee Figure Throttle Trigger TOP Clamp Handle BAR BottomBent END Silencer Guard Opening in Rear Housing Silencer Guard AssemblyAttaching the Shoulder Strap Grass Deflector and Blade Guard USEBlade Guard Drive Connector Spool RetainerGrass Deflector Converting from Trimmer to BrushcutterInstalling the String Head Installing the BladeConverting from Brushcutter to Trimmer Removing the BladeOperation Fuel and RefuellingOperating the Trimmer Advancing the String Cutting TipsGrass Deflector Line Trimming CUT- OFF Blade Operating the Brushcutter TRI-ARC BladeCutting Technique Blade See Figures 14 Starting and StoppingTo Start a Cold Engine To Start a Warm EngineSpool Replacement EZ Line TAP Advance System MaintenanceNEW PRE-WOUND Spool See Figures 16Blade Protector Replacing and Cleaning AIR Filter Cleaning the Exhaust Port and SilencerSpark Arrester See Figures 23Fuel CAP Sparking PlugStorage 1 Month or Longer Idle speed. See Figure TroubleshootingIdle Speed Screw Needle Safety Directive WarrantyGuarantee Statement Rtsa / Rtuk / RTG EC Declaration of ConformityRyobi Technologies GmbH
Top Page Image Contents