Ryobi RY08554 manual Assembly, Packing List, Assembling the Blower Tubes, Grounding instructions

Page 9

ASSEMBLY

UNPACKING

This product requires assembly.

nCarefully remove the product and any accessories from the box. Make sure that all items listed in the packing list are included.

nInspect the product carefully to make sure no breakage or damage occurred during shipping.

nDo not discard the packing material until you have care- fully inspected and satisfactorily operated the product.

nIf any parts are damaged or missing, please call 1-800-860-4050 for assistance.

Packing List

Blower

Upper Blower Tube Sweeper Nozzle High Velocity Nozzle Vacuum Handle Vacuum Handle Knobs (2) Grounding Wire

Upper and Lower Vacuum Tubes Vacuum Tube Screws (2) Vacuum Bag Assembly Vacuum Bag Adaptor

2-Cycle Engine Lubricant Operator’s Manual

NOTE: Read and remove all hang tags and store with your operator’s manual.

WARNING:

If any parts are damaged or missing do not operate this product until the parts are replaced. Failure to heed this warning could result in serious personal injury.

WARNING:

Do not attempt to modify this product or create acces- sories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.

WARNING:

To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts.

ASSEMBLING THE BLOWER TUBES

See Figure 2.

Align raised tabs on main housing to the slots on upper tube; slide together and tighten securely by twisting. Check tightness after initial run and retighten if needed.

To remove the tubes, rotate the tubes to unlock them and remove from the blower housing outlet.

grounding instructions

See Figure 3.

Before installing the vacuum handle, connect the grounding wire as shown. This will help prevent static shock when using the vacuum in low humidity conditions.

sweeper nozzle

upper blower

tube

Fig. 2

Fig. 3

Image 9
Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction Table of ContentsService General Safety RulesRefueling Specific Safety RulesSymbol Name Explanation SymbolsSymbol Signal Meaning Product Specifications FeaturesUpper handle ChokeSimple Start MotorThrottle Trigger See Figures 1a 1bPacking List AssemblyAssembling the Blower Tubes Grounding instructionsInstalling the vacuum bag InstalLING the Vacuum handleVacuum handle Vacuum handle knobs See Figures 5See Figures 7 Installing the vacuum tubesApplications OperationMixing the Fuel Premium Exact MIXStarting and Stopping Oxygenated FuelsSee Figures 9 Operating the Blower Cruise controlSee Figures 11 Maintenance General MaintenanceVacuum Operation Cleaning the Exhaust PORT, Muffler and spark arrestor Cleaning the AIR Filter ScreenSpark Plug replacement Vacuum BAGProblem Cause Remedy TroubleshootingLimited Warranty Statement WarrantyMANUFACTURER’S Warranty Coverage Clean Every Replace Every Each Use Hours Every 25 Hours Emissions Parts Inspect Before Clean EveryIncludes Fuel FilterPage California Proposition Parts and Service