Ryobi RY43160 Connecting the Poles, Button Handle Pole Lower Collar Threaded Base, Cord

Page 11

ASSEMBLY

 

BUTTON

 

HANDLE POLE

 

 

 

LOWER COLLAR

 

THREADED BASE

 

 

BUTTON

INTERMEDIATE

THREADED

POLE

BASE

CORD

 

 

UPPER COLLAR

POWERHEAD POLE

 

 

 

 

 

Fig. 3

CONNECTING THE POLES

See Figure 3.

Before using the pole saw, a one-time assembly is required. When removed from the box, the three poles are connected by an electrical cord as shown above.

nRemove the four (4) rubber cord protectors from inside the poles. This material protects the cord during shipping and MUST be discarded imme- diately.

nUnscrew the lower collar from the threaded base on the intermediate pole and push back over the cord to the handle pole shaft as shown.

nInsert the handle pole into the intermediate pole and slide together until you hear the button click. The tubes are egg-shaped and will only install one way.

nLower the collar on the handle pole to the threaded base on the intermediate pole and rotate clock- wise to secure.

nRepeat this process to attach the intermediate pole to the powerhead pole.

NOTE: Once assembled correctly, handle pole and powerhead pole should not be able to separate from intermediate pole when pulled. Repeat above steps if poles can be separated from intermediate pole.

WARNING:

Failure to lock powerhead pole as directed above could result in serious injury or death.

Page 11 — English

Page 10 Page 12
Image 11
Page 10 Page 12
Contents ALL Versions Toutes LES Versions Todas LAS Versiones Save this Manual for Future ReferenceIntroduction Table of ContentsRead ALL Instructions Important Safety InstructionsSpecific Safety Rules Specificsafetyrules Symbol Name Explanation SymbolsSymbol Signal Meaning Extension Cords ElectricalDouble Insulation Electrical ConnectionRetainer Product SpecificationsOIL CAP Telescoping Pole LOCK-OUT Button ScabbardAssembly FeaturesCord Connecting the PolesPowerhead Pole Button Handle Pole Lower Collar Threaded BaseApplications OperationAdding BAR and Chain Lubricant Starting and Stopping Connecting to Power SupplyAdjusting Telescoping Pole LOCK-OUT Button Switch Trigger Cord RetainerCollar Load Second CUT BASIC Cutting ProcedurePreparation for Cutting See Figures 7Maximum Limbing and PruningSee Figures 9 Flats MaintenanceGeneral Maintenance Chain TensionNUT Replacing the BAR and ChainSee Figures 13 Drivecase Chain Cover BAR BAR NUT Sprocket Tensioning PINRaker Depth Gauge Clearance Chain MaintenanceChain Oiler BAR NUT Remove CAP BAR LubeLeft Hand Cutters Right Hand HOW to Sharpen the CuttersSee Figures 19 GulletStoring the Product TroubleshootingProblem Cause Remedy Limited Warranty Statement WarrantyTechtronic Industries North AMERICA, INC OPERATOR’S Manual / Electric Pole SAWAVERTISSEMENT  Advertencia
Top Page Image Contents