Ryobi RY43160 manuel dutilisation Chain Oiler, Chain Maintenance, BAR NUT Remove CAP BAR Lube

Page 18

MAINTENANCE

CHAIN OILER

See Figure 17.

nUse Premium Bar and Chain Lubricant. It is designed for chains and chain oilers and is formulated to perform over a wide temperature range with no dilution required.

nRemove the cap and carefully pour approxi- mately 2 oz. of bar and chain lubricant into the bar lube reservoir.

nReplace the cap and tighten securely.

nCheck and refill the bar lube reservoir every time the pole saw is used.

NOTE:  Do not use dirty, used, or otherwise con- taminated lubricants. Damage may occur to the oil pump, bar, or chain.

CHAIN MAINTENANCE

See Figure 18.

For smooth and fast cutting, the chain needs to be maintained properly. The following conditions indicate that the chain requires sharpening: 

nWood chips are small and powdery

nChain must be forced through the wood during cutting

nChain cuts to one side

During maintenance of the chain, consider the following:

nImproper filing angle of the side plate can in- crease the risk of a severe kickback.

nDepth gauge (or raker clearance) setting de- termines the height the cutter enters the wood and the size of the wood chip that is removed. Too much clearance increases the potential for kickback. Too little clearance decreases the size of the wood chip thus decreasing the chain's cutting ability.

nIf cutter teeth have hit hard objects such as nails and stones, or have been abraded by mud or sand on the wood, have service dealer sharpen chain.

BAR

NUT

Fig. 16

REMOVE

CAP

BAR LUBE

RESERVOIR

Fig. 17

RAKER (DEPTH GAUGE)

CLEARANCE

.025 in.

Fig. 18

Page 18 — English

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Save this Manual for Future Reference ALL Versions Toutes LES Versions Todas LAS VersionesTable of Contents IntroductionImportant Safety Instructions Read ALL InstructionsSpecific Safety Rules Specificsafetyrules Symbols Symbol Name ExplanationSymbol Signal Meaning Electrical Connection ElectricalDouble Insulation Extension CordsTelescoping Pole LOCK-OUT Button Scabbard Product SpecificationsOIL CAP RetainerFeatures AssemblyButton Handle Pole Lower Collar Threaded Base Connecting the PolesPowerhead Pole CordOperation Adding BAR and Chain LubricantApplications LOCK-OUT Button Switch Trigger Cord Retainer Connecting to Power SupplyAdjusting Telescoping Pole Starting and StoppingSee Figures 7 BASIC Cutting ProcedurePreparation for Cutting Collar Load Second CUTLimbing and Pruning See Figures 9Maximum Chain Tension MaintenanceGeneral Maintenance FlatsDrivecase Chain Cover BAR BAR NUT Sprocket Tensioning PIN Replacing the BAR and ChainSee Figures 13 NUTBAR NUT Remove CAP BAR Lube Chain MaintenanceChain Oiler Raker Depth Gauge ClearanceGullet HOW to Sharpen the CuttersSee Figures 19 Left Hand Cutters Right HandTroubleshooting Problem Cause RemedyStoring the Product Warranty Limited Warranty StatementAdvertencia OPERATOR’S Manual / Electric Pole SAWAVERTISSEMENT  Techtronic Industries North AMERICA, INC
Top Page Image Contents