BEFORE ASSEMBLY
1.Shut off the pressure washer and turn off the water supply.
2.Pull trigger on gun handle to relieve any water pressure.
3.Disconnect the high pressure hose from the gun.
TO ASSEMBLE HOSE REEL
1.Attach handle to flange assembly. NOTE: Screws must be inserted from the inside of hose reel and secured with nuts on the outside as shown. Tighten securely.
2.Remove quick connect plug from high pressure hose.
3.Apply sealant tape to hose reel inlet hose and assemble quick connect to hose reel inlet hose.
4.Bolt hose reel to reel bracket as shown. Tighten securely. NOTE: If unit is not equipped with hose reel bracket order hose reel bracket (part number D23163).
5.Apply sealant tape to swivel end of high pressure hose. IMPORTANT: The high pressure hose has a swivel end and fixed end. The swivel end must be used to attach high pressure hose to hose reel, see below to determine fixed and swivel ends. If quick connect socket is assembled on swivel end, remove and connect it to fixed end of hose.
hose end without swivel
hose end with swivel
6. Feed high pressure hose through slot
(1) in flange assembly and connect to swivel (2). Tighten securely.
1 
2
7.Make a loop in hose as shown. Place hose into hose clamp (3), squeeze hose clamp together, slide onto long screw post, and secure with nut (4). Tighten securely. NOTE: Do not overbend or kink hose.
3 
4
D26052 | 2- ENG |