Porter-Cable D27245-028-0 instruction manual Maintenance

Page 16

MAINTENANCE

CUSTOMER RESPONSIBILITIES TABLE

 

Before

Every 25

Every 50

Every 100

 

each

Hours of

Hours of

Hours of

MAINTENANCE TASK

use

Every

Every

Every

 

Season

Season

Season

 

 

 

 

 

 

 

Check oil level

X

See Note 2

 

 

 

 

 

 

 

Change oil

 

 

See Note 1

 

 

 

 

 

 

Clean Air Filter Assembly

 

X

 

 

 

 

 

 

 

Check Spark Plug

 

X

 

X

 

 

 

 

 

Prepare Unit for Storage

Prepare

unit for storage if it is to remain

 

idle for more than 30 days.

 

Note 1: Change oil after first two (2) operating hours and every 50 operating hours thereafter, more often if operated in extreme dusty or dirty conditions.

Note 2: Check oil after 5 hours of operation.

GENERAL RECOMMENDATIONS

The warranty of the generator does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, operator must maintain the generator as instructed in this manual.

ENGINE MAINTENANCE

Refer to the Engine Operator's manual for service and maintenance of the engine.

GENERATOR MAINTENANCE

Your generator should be kept clean and dry at all times. The generator should not be stored or operated in environments that includes excessive moisture, dust or any corrosive vapors. If these substances are on the generator, clean with a cloth or soft bristle brush. Do not use a garden hose or anything with water pressure to clean the generator. Water may enter the cooling air slots and could possibly damage the rotor, stator and the internal windings of the gen head.

GROUND FAULT CIRCUIT INTERRUPTER GFCI RECEPTACLE)

MONTHLY: For maximum protection against electrical shock the GFCI should be tested monthly.

To test:

1.Depress the TEST button. The RESET button should extend. If the RESET button does not extend, notify a DeVilbiss Air Power Company Authorized Warranty Service Center.

2.To restore power, depress the RESET button firmly into the GFCI unit until an audible click is heard. If reset properly, the RESET button is flush with the surface of the test button. When the button stays in, the power is ON.

D27245

16- ENG

Image 16
Contents Generator Consumer Safety Information Consumer General and Service InformationRead and understand all safety warnings Safety Guidelines / Definitions Important Safety InstructionsWhen installing a Double Risk of Electrocution and FireWhen damaged Risk of Electrocution and FireOperation Generator in rainUnit Indoors or in ANY Risk of FireConfined Area Risk of Breathing Inhalation Hazard Risk of Unsafe OperationRisk of HOT Surfaces Specifications BSV750Risk of Moving Parts Risk from LiftingAssembly Remove Generator from CartonOther Loose Parts Grounding the GeneratorTypical Installation of Battery UnitDouble Throw Transfer Switch Extension Cord Wire Gauge Chart Length Size AmperageObtaining Electricity from the Generator Extension CordsOperation Before Start UP 12V DC OutletGas To Start the Engine Connecting Electrical Loads Stopping EngineMaintenance Battery StorageEngine Preparation GeneratorDetermining Wattage Requirements Wattage CalculationsRunning Watts Starting Watts Starting Wattage Requirements Volts X Amp = Watts Example 120 volts x 10 amps = 1200 wattsHousehold Wattage Calculator Appliance or Load Device Typical Device Wattage TotalProblem Limited Warranty Responsibility of Original Purchaser initial UserENG D27245 Quick Facts