Adjustments
Main Belt Tension
1.Disconnect machine from power source.
2.Open back panels to expose the motor, pulleys and belts, as shown in Figure 10. Loosen hex nut (Fig. 11) and turn the adjustment screw as needed to adjust the tension. Proper tension is achieved when there is a small amount of deflection by using moderate finger pressure on the belt midway between the pulleys.
3.Tighten hex nut (Fig. 11) and replace panels.
Figure 10
Figure 11
Gearbox Belt Tension
1.Disconnect machine from power source.
2.Open lower back panel and loosen nuts on the motor base (Fig. 12). Adjust motor base up or down as needed, then tighten nuts. Proper tension is achieved when there is a small amount of deflection by using finger pressure on the belt midway between the pulleys.
3.Replace panels.
Figure 12
11