Installing/Changing Blade
1.Disconnect machine from power source.
2.Unscrew knurled knob on blade guard and swing guard away, as shown in Figure 8.
3.Loosen the arbor lock lever (A, Figure 7) and raise the arbor with the handwheel (B, Figure 7) until the blade can slip on to the arbor without interference from the caterpillar.
4.Place the arbor wrench on the flat of the arbor shaft. Place the
5.Remove screw and flange and install new blade, making sure to orient it properly - the teeth at bottom of blade should face toward infeed side of machine (as shown in Figure 6).
6.Replace flange and screw, and tighten screw with the
7.Lower the blade down into the inserts on the caterpillar track (blade teeth should be 0.5mm to 1.5mm lower than caterpillar surface).
The blade teeth should not contact the bottom of the inserts.
8. Close blade guard and tighten knurled knob.
Mounting the Fence
1.Slide the fence casting onto the end of the guide bar while pulling back the main lock handle (Figure 9).
2.The fence is moved along the guide bar by rotating the handwheel. Use the main lock handle to secure the fence casting in place.
3.Loosen the other lock handle and slide the aluminum fence onto the casting. Tighten the handle.
Figure 7
Figure 8
Figure 9
10