Poulan 954 14 01-10, QC38B, 183159 owner manual Container Mounting See No hardware required

Page 7

4

CONTAINER ASSEMBLY (See Fig. 4)

No hardware required

1.Place bottom half inside of top half, as shown.

2.Place one foot inside bottom half and lift top half to meet bottom half.

3.Press halves tightly together while lifting top to lock into place as shown.

IMPORTANT:BEFORE LOCKINGTHETABS,HOOKED EDGES ON BOTH HALVES MUST OVERLAP TO FORM SEAL AS SHOWN IN INSET.

4. Repeat for other containers.

CONTAINER

BOTTOM HALF

02089

CONTAINER

TOP HALF

 

39

 

 

027

PRESS TOGETHER

 

 

CONTAINER

 

TO FORM SEAL

 

WHILE LIFTING

TOP HALF

 

 

TOP HALF

 

 

CONTAINER

BOTTOM

HALF

LOCKING

TAB

FIG. 4

ASSEMBLY CHECK: Squeeze sides of lower half of con- tainer and check that there is no gap between upper and lower halves. If a gap appears, unlock tabs to separate container halves and repeat instructions above.

02097

5 CONTAINER MOUNTING (See Fig. 5) No hardware required

1.Install one container to left side first with warning to outside of unit. Install other container to right side.

NOTE: Right container should always overlap left container at center support.

2.Close cover and lock latch handle over center support tube.

COVER LATCH

HANDLE

CONTAINER

WARNING

G NI

N ARW

CONTAINER

HANDLE

 

WARN

ING

 

 

 

 

 

 

 

CENTER

 

 

 

SUPPORT

 

 

 

TUBE

 

 

02082

 

 

 

 

CONTAINER

 

 

FIG. 5

WARNING

 

 

 

6

LOWER CHUTE (See Fig. 6)

Use Hardware - - GROUP "C"

1.Raise and hold deflector shield in upright position.

2.Slide back edge of chute over rear corner of mower deck and pivot forward.

3.Align slot in lower chute with hex bolt in mower deck baffle and close chute over deck openning.

4.Secure with washer and wing nut.

CAUTION: Do not remove discharge guard from mower. Raise and hold guard when attaching lower chute and allow it to rest on chute while in operation.

DEFLECTOR SHIELD

WASHER

MOWER DECK

BAFFLE

02343

HEX BOLT

WING NUT

7

FIG. 6

Image 7
Contents 341 WNER’S ManualSafe Operation Practices for Ride-On Mowers Table of Contents Carton Contents Parts Identification AssemblyUse Hardware - Group a Use Hardware - Group B To Remove the Support Assembly See CSupport Assembly See Fig See Figs a & 2BNo hardware required Container Mounting See No hardware requiredNo hardware required Upper Chute See Figs a & 7BLevel Mower Deck No hardware required Tips for Improved Bagging Operation OperationCustomer Responsibilities MAINTENANCE,SERVICE or Adjust MentsBlade Care Page Repair Parts / Pièces DE Rechange KEY Part Description