Poulan 194604 manual To Replace Mower Drive Belt See Fig, Mower Drive Belt Removal, Belt Routing

Page 22

SERVICE AND ADJUSTMENTS

TO REPLACE MOWER DRIVE BELT (See Fig. 24)

MOWER DRIVE BELT REMOVAL

•Park tractor on a level surface. Engage parking brake.

•Lower attachment lift lever to its lowest position.

•Disengage belt tension rod from lock bracket.

CAUTION: Belt tension rod is spring loaded. Have a ﬁrm grip on rod and release slowly.

•Remove screws from R.H. and L.H. mandrel covers and remove covers.

•Remove any dirt or grass clippings which may have accumulated around mandrels and entire upper deck surface.

MOWER DRIVE BELT INSTALLATION

•Install belt around both mandrel pulleys and around idler pulleys as shown.

•Install belt onto electric clutch pulley.

IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES.

•Reassemble R.H. and L.H. mandrel covers. Securely tighten all screws.

•Engage belt tension rod on locking bracket.

CAUTION: Belt tension rod is spring loaded. Have a tight grip on rod and engage slowly.

•Raise attachment lift lever to highest position.

•Remove belt from electric clutch pulley, both mandrel pulleys and all idler pulleys.

BELT ROUTING

	L.H. MANDREL
	COVER
	LOCKING BRACKET
BELT TENSION	ELECTRIC
ROD (DISENGAGED	ELECTRIC
POSITION)	CLUTCH
	PULLEY

R.H. MANDREL

COVER

R.H.

MANDREL

IDLER

PULLEYS

FIG. 24

22

Image 22

Contents Model Always Wear EYE Protection During OperationGeneral Operation Safe Operation Practices for Ride-On MowersII. Slope Operation III. Children ServiceGeneral Service IV. TowingTable of Contents Unassembled Parts To Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidInstall Seat See Fig Assemble Gauge Wheels to Mower Deck SeeInstall Mower and Drive Belt Sees To Attach Nose Roller See FigCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Height Adjustment Knob Used to adjust the mower height Know Your TractorHOW to USE Your Tractor To Operate Mower See Fig To Adjust Gauge Wheels See FigUsing the Reverse Operation System Reverse Operation System ROSTowing Carts and Other ATTACH- Ments Before Starting the EngineTo Transport Check Engine OIL LevelMowing Tips General Recommendations MaintenanceLubrication Chart Before Each USETractor Blade Removal See FigBelts BatteryEngine Transaxle CoolingCleaning To Level Mower Housing Service and AdjustmentsTo Install Mower To Remove Mower See FigFRONT-TO-BACK Adjustment See Figs Mower Drive Belt Removal Mower Drive Belt InstallationTo Replace Mower Drive Belt See Fig Belt RoutingTo Check and Adjust Brake See Fig To Adjust Attachment Clutch See FigTo Replace Motion Drive Belt See Fig To Start Engine with a Weak Battery See Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbEngine OIL OtherFuel System CylindersTroubleshooting Points Problem Cause CorrectionEngine dies when Limited Warranty Service Notes Service Notes Service Notes Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service