ASSEMBLY
•Sit on seat in operating position, depress clutch/brake pedal and set the parking brake.
•Place motion control lever in neutral (N) position.
•Press lift lever plunger and raise attachment lift lever to its highest position.
•Remove key from bag and start the engine (see "TO START ENGINE" in the Operation section of this man- ual). After engine has started, move throttle control to idle (slow) position.
•Release parking brake.
•Slowly move the motion control lever forward and slowly drive tractor off skid.
•Apply brake to stop tractor, set parking brake and place motion control lever in neutral position.
•Turn ignition key to "STOP" position.
Continue with the instructions that follow.
TO INSTALL BAGGER COMPONENTS TO TRACTOR (See Figs. 4A-4D)
•Remove discharge chute from rear of tractor. Unhook the two (2) straps and pull chute out and away from tractor.
•Remove the two (2) 3/8 nuts and fl at washers from the bolts at the tractor back plate.
DISCHARGE
CHUTE
3/8 NUT 
FLATWASHER
02277
FIG. 4A
•Using the nuts and fl at washers removed from tractor back plate, install the bagger support tube to the back plate as shown. Tighten securely.
SUPPORT
TUBE
FLAT
WASHER
3/8 NUT
BOLT | 02330 |
|
FIG. 4B
•Install the two upper support brackets through the back plate and to the chassis, install the clevis pin 10x17mm and secure with retainer spring.
•Assemble both support brackets to the outside of the bagger support tube using two each 3/8 x 63,5mm hex bolts13/32" I.D.flat washers and 3/8 locknuts from parts bag. Tighten securely.
•Replace discharge chute into rear opening of tractor. Secure the chute with the two hook straps.
CLEVIS PIN 10 X 17MM
3/8 LOCK NUT
SUPPORT BRACKET
10,3MM (13/32")
FLAT WASHER
3/8 X 63,5MM HEX BOLT
RETAINER SPRING | 03 |
28 | |
| 0 |
FIG. 4C
NOTE:The strap hook must go through the discharge chute only. Do not allow the hook to enter the slot in the tractor back plate.This will allow the discharge chute to float with the mower deck when moving on uneven terrain.
DISCHARGE
CHUTE
HOOK
02306
BACKPLATE
SLOT
FIG. 4D
TO ASSEMBLE BAGGER (See Figs. 5A-5C)
•Unfold bag by pivoting front bagger tube all the way forward and pressing the bottom vinyl binding onto the tube.
•Inside the bag, install spreader bars and retainer springs onto pins on both sides of bag as shown.
•Press the vinyl bindings onto the sides of front bagger tube.
•Slide the bagger dump handle through the hole in the bagger top, install the clevis pin 10 x 44mm and secure with retainer spring.
FRONT BAGGER TUBE | 05 |
029 | |
|
VINYL BINDING
FIG. 5A
8