Bagger Adjustment See, Horizontal Adjustment

ASSEMBLY

SPREADER BARS

RETAINER

SPRING

VINYL

BINDING

RETAINER SPRING

06 029

FIG. 5B

•Push cap over end of bagger dump handle.

NOTE: For future use, the clevis pin may be removed in order to use the handle to clear the chute in the event it has become clogged.

DUMP HANDLE

TUBE

CLEVIS PIN 10 X 44MM

RETAINER SPRING

•Install and carefully lower bagger to actuate latch.

•Measure distance between bagger and latch as shown.

6MM (1/4") - 9MM (3/8")

TOP SURFACES

HORIZONTAL EVEN

ADJUSTMENT

BRACKET

VERTICAL	FIG. 7
ADJUSTMENT
BRACKET

02967

BAGGER

LATCH

FIG. 6

10MM (7/16") - 16MM (5/8")	02983

CAP

02907 BAGGER LATCH

FIG. 5C

BAGGER ADJUSTMENT (See Fig. 6 & 7)

For proper bag function and appearance, it may be nec- essary to adjust the bagger assembly.There should be 6mm (1/4")-9mm (3/8") gap between the bagger top and fender and the bagger top surface should be even with the top surface of the fender. To adjust bagger position:

HORIZONTAL ADJUSTMENT

•Slightly loosen the nuts securing the bagger RH and LH horizontal adjustment brackets.Loosen only enough so the brackets keep their position, but allow them to be moved.

•Move the brackets the amount forward or backward you wish the bag assembly to move. Retighten the nuts securely.

VERTICAL ADJUSTMENT

•Slightly loosen the nuts securing the vertical adjust- ment brackets. Loosen only enough so the brackets keep their position, but allow them to be moved.

•Move the brackets the amount up or down you wish the bag assembly to move. Retighten the nuts securely.

•Reinstall the bagger assembly and check the bagger to fender ﬁ t. If necessary, repeat the procedure until proper ﬁt is attained.

•After proper ﬁ t is attained, remove bagger from trac- tor and install bagger latch (4) to tractor back plate as shown. Tighten securely.

FIG. 7

If distance is not 10mm - 16mm carefully remove bagger and repeat vertical adjustment as needed.

TO ASSEMBLE AND INSTALL MULCHER PLUG (See Fig. 8)

•Remove spring retainer and pin from handle.

•Insert plug into handle. Make sure that the letter "A" on both the plug and handle are on the same side and that they can both be seen from the top when laying on the ground.

•Secure with pin and retainer spring provided. For in- stallation see "To Convert Mower" in Section 5 of this manual.

HANDLE

RETAINER

SPRING

PIN	A

PLUG

02214

FIG. 8