Cisco Systems UCSCPCIEBTG, 57712 manual Sending a Test Snmp Trap Message, Configuring SNMPv3 Users

Configuring Communication Services

Sending a Test SNMP Trap Message

Enabled: yes

SNMP version: 2

Trap type: inform

SNMP user: user1

IPv4 Address: 192.2.3.4

Delete Trap: no

Server /snmp/trap-destination #

Sending a Test SNMP Trap Message

Before You Begin

You must log in with admin privileges to perform this task.

Procedure

	Command or Action	Purpose
Step 1	Server# scope snmp	Enters the SNMP command mode.
Step 2	Server /snmp # sendSNMPtrap	Sends an SNMP test trap to the configured SNMP trap
		destination that are enabled.
		Note	The trap must be configured and enabled in order
			to send a test message.

This example sends a test message to all the enabled SNMP trap destinations:

Server# scope snmp

Server /snmp # sendSNMPtrap

SNMP Test Trap sent to the destination.

Server /snmp #

Configuring SNMPv3 Users

Before You Begin

•You must log in as a user with admin privileges to perform this task.

•SNMP must be enabled and saved before these configuration commands are accepted.

Procedure

	Command or Action	Purpose
Step 1	Server# scope snmp	Enters the SNMP command mode.
Step 2	Server /snmp # scope v3users	Enters the SNMPv3 users command mode for the
	number	specified user number.
Step 3	Server /snmp/v3users # set v3add	Adds or deletes an SNMPv3 user. This can be one of the
	{yes no}	following:

	Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
140	OL-28893-01