Cisco Systems 57712 Rate-limit off rate, Order any, Error-detect-timeout msec, Error-recovery

Managing Network Adapters

Modifying vHBA Properties

	Command or Action	Purpose
Step 12	Server /chassis/adapter/host-fc-if # set	Specifies a maximum data rate for the vHBA. The
	rate-limit {off rate}	range is 1 to 10000 Mbps; the default is off.
		This setting is not functional in NIV mode.
Step 13	Server /chassis/adapter/host-fc-if # set	Specifies the relative order of this device for PCIe bus
	order {any 0-99}	device number assignment; the default is any.
Step 14	Server /chassis/adapter/host-fc-if # set	Specifies the error detect timeout value (EDTOV),
	error-detect-timeout msec	the number of milliseconds to wait before the system
		assumes that an error has occurred. The range is 1000
		to 100000; the default is 2000 milliseconds.
Step 15	Server /chassis/adapter/host-fc-if # set	Specifies the resource allocation timeout value
	resource-allocation-timeout msec	(RATOV), the number of milliseconds to wait before
		the system assumes that a resource cannot be properly
		allocated. The range is 5000 to 100000; the default is
		10000 milliseconds.
Step 16	Server /chassis/adapter/host-fc-if # set	Specifies the maximum size of the Fibre Channel
	max-field-size size	frame payload (in bytes) that the vHBA supports. The
		range is 1 to 2112; the default is 2112 bytes.
Step 17	Server /chassis/adapter/host-fc-if # scope	Enters the Fibre Channel error recovery command
	error-recovery	mode.
Step 18	Server	Enables or disables FCP Error Recovery. The default
	/chassis/adapter/host-fc-if/error-recovery	is disable.
	# set fcp-error-recovery {disable
	enable}
Step 19	Server	Specifies the link down timeout value, the number of
	/chassis/adapter/host-fc-if/error-recovery	milliseconds the uplink port should be offline before
	# set link-down-timeout msec	it informs the system that the uplink port is down and
		fabric connectivity has been lost. The range is 0 to
		240000; the default is 30000 milliseconds.
Step 20	Server	Specifies the port down I/O retries value, the number
	/chassis/adapter/host-fc-if/error-recovery	of times an I/O request to a port is returned because
	# set port-down-io-retry-count count	the port is busy before the system decides the port is
		unavailable. The range is 0 to 255; the default is 8
		retries.
Step 21	Server	Specifies the port down timeout value, the number of
	/chassis/adapter/host-fc-if/error-recovery	milliseconds a remote Fibre Channel port should be
	# set port-down-timeout msec	offline before informing the SCSI upper layer that the
		port is unavailable. The range is 0 to 240000; the
		default is 10000 milliseconds.
Step 22	Server	Exits to the host Fibre Channel interface command
	/chassis/adapter/host-fc-if/error-recovery	mode.
	# exit

Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5

OL-28893-01 89