Cisco Systems UCSCPCIEBTG, 57712 manual Deleting a vNIC, Host-eth-if name

Managing Network Adapters

Deleting a vNIC

Procedure

	Command or Action	Purpose
Step 1	Server# scope chassis	Enters the chassis command mode.
Step 2	Server /chassis # scope adapter	Enters the command mode for the adapter card at the PCI
	index	slot number specified by index.
		Note	The server must be powered on before you can
			view or change adapter settings.
Step 3	Server /chassis/adapter # create	Creates a vNIC and enters the host Ethernet interface
	host-eth-if name	command mode. The name argument can be up to 32
		ASCII characters.
Step 4	Server /chassis/adapter/host-eth-if #	(Optional)
	set channel-number number	If NIV mode is enabled for the adapter, you must assign
		a channel number to this vNIC. The range is 1 to 1000.
Step 5	Server /chassis/adapter/host-eth-if #	Commits the transaction to the system configuration.
	commit	Note	The changes will take effect upon the next server

reboot.

This example creates a vNIC on adapter 1:

Server# scope chassis

Server /chassis # scope adapter 1

Server /chassis/adapter # create host-eth-if Vnic5

Server /chassis/adapter/host-eth-if *# commit

New host-eth-if settings will take effect upon the next server reset

Server /chassis/adapter/host-eth-if #

Deleting a vNIC

Procedure

	Command or Action	Purpose
Step 1	Server# scope chassis	Enters the chassis command mode.
Step 2	Server /chassis # scope adapter	Enters the command mode for the adapter card at the PCI
	index	slot number specified by index.
		Note	The server must be powered on before you can
			view or change adapter settings.

Step 3	Server /chassis/adapter # delete
	host-eth-if name
Step 4	Server /chassis/adapter # commit

Deletes the specified vNIC.

Note You cannot delete either of the two default vNICs, eth0 or eth1.

Commits the transaction to the system configuration.

	Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
106	OL-28893-01