Cisco Systems 57712 Trust-host-cos disable enable, Vlan-mode access trunk, Channel-number number

Managing Network Adapters

Modifying vNIC Properties

	Command or Action	Purpose
		Note	If NIV is enabled, this setting is determined
			by the switch, and the command is ignored.
Step 9	Server /chassis/adapter/host-eth-if # set	Specifies whether the vNIC will trust host CoS or will
	trust-host-cos {disable enable}	remark packets. The behavior is as follows:
		• disable —Received packets are remarked with
			the configured CoS. This is the default.
		• enable —The existing CoS value of received
			packets (host CoS) is preserved.
Step 10	Server /chassis/adapter/host-eth-if # set	Specifies the relative order of this device for PCI bus
	order {any 0-99}	device number assignment; the default is any.
Step 11	Server /chassis/adapter/host-eth-if # set	Specifies the default VLAN for this vNIC. Valid VLAN
	vlan {none vlan-id}	numbers are 1 to 4094; the default is none.
		Note	If NIV is enabled, this setting is determined
			by the switch, and the command is ignored.
Step 12	Server /chassis/adapter/host-eth-if # set	Specifies the VLAN mode for the vNIC. The modes
	vlan-mode {access trunk}	are as follows:
		• access —The vNIC belongs to only one VLAN.
		• trunk —The vNIC can belong to more than one
			VLAN. This is the default.
		Note	If NIV is enabled, this setting is determined
			by the switch, and the command is ignored.
Step 13	Server /chassis/adapter/host-eth-if # set	Specifies a maximum data rate for the vNIC. The range
	rate-limit {off rate}	is 1 to 10000 Mbps; the default is off.
		Note	If NIV is enabled, this setting is determined
			by the switch, and the command is ignored.
Step 14	Server /chassis/adapter/host-eth-if # set	Specifies whether the vNIC can be used to perform a
	boot {disable enable}	PXE boot. The default is enable for the two default
		vNICs, and disable for user-created vNICs.
Step 15	Server /chassis/adapter/host-eth-if # set	If NIV mode is enabled for the adapter, select the
	channel-number number	channel number that will be assigned to this vNIC. The
		range is 1 to 1000.
Step 16	Server /chassis/adapter/host-eth-if # set	If NIV mode is enabled for the adapter, select the port
	port-profile name	profile that should be associated with the vNIC.
		Note	The name must be a port profile defined on
			the switch to which this server is connected.
Step 17	Server /chassis/adapter/host-eth-if # set	If NIV mode is enabled for the adapter, enable this
	uplink-failover {disable enable}	setting if traffic on this vNIC should fail over to the

Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5

OL-28893-01 101