Managing Network Adapters

Modifying vHBA Properties

Modifying vHBA Properties

Before You Begin

You must log in with admin privileges to perform this task.

Procedure

 

Command or Action

Purpose

 

Step 1

Server# scope chassis

Enters the chassis command mode.

Step 2

Server /chassis # show adapter

(Optional) Displays the available adapter devices.

Step 3

Server /chassis # scope adapter index

Enters the command mode for the adapter card at the

 

 

PCI slot number specified by index.

 

 

Note

The server must be powered on before you

 

 

 

can view or change adapter settings.

Step 4

Server /chassis/adapter # scope host-fc-if

Enters the host Fibre Channel interface command

 

{fc0 fc1 name}

mode for the specified vHBA.

Step 5

Server /chassis/adapter/host-fc-if # set

Specifies a unique World Wide Node Name (WWNN)

 

wwnn wwnn

for the adapter in the form hh:hh:hh:hh:hh:hh:hh:hh.

 

 

Unless specified by this command, the WWNN is

 

 

generated automatically by the system.

Step 6

Server /chassis/adapter/host-fc-if # set

Specifies a unique World Wide Port Name (WWPN)

 

wwpn wwpn

for the adapter in the form hh:hh:hh:hh:hh:hh:hh:hh.

 

 

Unless specified by this command, the WWPN is

 

 

generated automatically by the system.

Step 7

Server /chassis/adapter/host-fc-if # set

Enables or disables FC SAN boot. The default is

 

boot {disable enable}

disable.

 

Step 8

Server /chassis/adapter/host-fc-if # set

Enables or disables persistent LUN binding. The

 

persistent-lun-binding {disable

default is disable.

 

enable}

 

 

Step 9

Server /chassis/adapter/host-fc-if # set

Specifies a MAC address for the vHBA.

 

mac-addr mac-addr

 

 

Step 10

Server /chassis/adapter/host-fc-if # set

Specifies the default VLAN for this vHBA. Valid

 

vlan {none vlan-id}

VLAN numbers are 1 to 4094; the default is none.

Step 11

Server /chassis/adapter/host-fc-if # set

Specifies the class of service (CoS) value to be marked

 

cos cos-value

on received packets unless the vHBA is configured

 

 

to trust host CoS. Valid CoS values are 0 to 6; the

 

 

default is 0. Higher values indicate more important

 

 

traffic.

 

This setting is not functional in NIV mode.

 

Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5

88

OL-28893-01

Page 103 Page 105
Page 104
Image 104
Cisco Systems UCSCPCIEBTG, 57712 manual Modifying vHBA Properties
Page 103 Page 105
Top Page Image Contents