Cisco Systems 57712, UCSCPCIEBTG manual Default configuration, Server /chassis/flexflash # commit

Managing the Server

Retaining the Configuration of the Flexible Flash Controller

•The card read/write error counts and read/write threshold are set to 0.

•Host connectivity could be disrupted.

Before You Begin

•You must log in with admin privileges to perform this task.

•Cisco Flexible Flash must be supported on your server.

Procedure

	Command or Action	Purpose
Step 1	Server# scope chassis	Enters the chassis command mode.
Step 2	Server /chassis # scope flexflash index	Enters the Cisco Flexible Flash controller command
		mode for the specified controller. At this time, the
		only permissible index value is FlexFlash-0.
Step 3	Server /chassis/flexflash # reset-config	Resets the configuration of the selected slot to the
	primary slot ID	default configuration.
Step 4	Server /chassis/flexflash # commit	Commits the transaction to the system configuration.

This example shows how to reset the configuration from a slot to the default configuration:

Server# scope chassis

Server /chassis # scope flexflash FlexFlash-0

Server /chassis/flexflash # reset-config slot1

This action will mark the slot1 as the healthy primary slot, and slot2 (if card exists) as unhealthy secondary active.

This operation may disturb the host connectivity as well. Continue? [yN] y

Server /chassis/flexflash/operational-profile *# commit

Server /chassis/flexflash/operational-profile #

Retaining the Configuration of the Flexible Flash Controller

You can copy the configuration of a given slot in the Cisco Flexible Flash card to the other slot. However, the slot from which the configuration is copied from must be of the SDK523 type. You can retain the configuration in the following situations:

•There are two unpaired SD cards

•The server is operating from a single SD card, and an unpaired SD card is in the other slot.

•One SD card supports firmware version 1.2.253, and the other SD card is either unpartitioned or supports firmware version 1.2.247.

Before You Begin

•You must log in with admin privileges to perform this task.

Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5

OL-28893-01 29