Cisco Systems UCSCPCIEBTG, 57712 manual Configuring IPv4

Configuring Network-Related Settings

Configuring IPv4

	Command or Action	Purpose
Step 4	Server /cimc/network # commit	Commits the transaction to the system
		configuration.

This example configures the common properties:

Server# scope cimc

Server /cimc # scope network

Server /cimc/network # set hostname Server

Server /cimc/network *# commit

Server /cimc/network #

Configuring IPv4

Before You Begin

You must log in as a user with admin privileges to configure IPv4 network settings.

Procedure

	Command or Action	Purpose
Step 1	Server# scope cimc	Enters the CIMC command mode.
Step 2	Server /cimc # scope network	Enters the CIMC network command mode.
Step 3	Server /cimc/network # set dhcp-enabled	Selects whether the CIMC uses DHCP.
	{yes no}	Note	If DHCP is enabled, we recommend that
			the DHCP server be configured to reserve
			a single IP address for the CIMC. If the
			CIMC is reachable through multiple ports
			on the server, the single IP address must
			be reserved for the full range of MAC
			addresses of those ports.

Step 4	Server /cimc/network #	set v4-addr	Specifies the IP address for the CIMC.
	ipv4-address
Step 5	Server /cimc/network #	set v4-netmask	Specifies the subnet mask for the IP address.
	ipv4-netmask
Step 6	Server /cimc/network #	set v4-gateway	Specifies the gateway for the IP address.
	gateway-ipv4-address
Step 7	Server /cimc/network # set dns-use-dhcp		Selects whether the CIMC retrieves the DNS server
	{yes no}		addresses from DHCP.
Step 8	Server /cimc/network #	set	Specifies the IP address of the primary DNS server.

preferred-dns-server dns1-ipv4-address

	Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
76	OL-28893-01