Cisco Systems UCSCPCIEBTG, 57712 manual Configuring Platform Event Trap Settings, Enabled yes

Configuring Platform Event Filters

Configuring Platform Event Trap Settings

	Command or Action	Purpose
		Note	For an alert to be sent, the filter trap settings must
			be configured properly and platform event alerts
			must be enabled.
Step 5	Server /fault/pef # commit	Commits the transaction to the system configuration.

This example configures the platform event alert for an event:

Server# scope fault
Server /fault # scope pef 11
Server /fault/pef # set action reboot
Server /fault/pef *# set send-alert yes
Server /fault/pef *# commit
Server /fault/pef # show		Action	Send Alert
Platform Event Filter Event
---------------------	---------------------------	-----------	------------------
11	Memory Assert Filter	reboot	yes

Server /fault/pef #

What to Do Next

If you configure any PEFs to send an alert, enable platform event alerts.

Configuring Platform Event Trap Settings

Before You Begin

You must log in with admin privileges to perform this task.

Procedure

	Command or Action	Purpose
Step 1	Server# scope fault	Enters the fault command mode.
Step 2	Server /fault # scope pef-destinations	Enters the platform event filter destinations
		command mode.
Step 3	Server /fault /pef-destinations # set	Enables the platform event trap destination.
	enabled yes
Step 4	Server /fault /pef-destinations # set addr	Specifies the destination IP address to which
	IP Address	platform event trap information is sent.
Step 5	Server /fault /pef-destinations # commit	Commits the transaction to the system
		configuration.

	Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
152	OL-28893-01