Cisco Systems 57712 manual Configuring Platform Event Filters, Enabling Platform Event Alerts

C H A P T E R 12

Configuring Platform Event Filters

This chapter includes the following sections:

•Platform Event Filters, page 149

•Enabling Platform Event Alerts, page 149

•Disabling Platform Event Alerts, page 150

•Configuring Platform Event Filters, page 150

•Configuring Platform Event Trap Settings, page 152

•Interpreting Platform Event Traps, page 153

Platform Event Filters

A platform event filter (PEF) can trigger an action and generate an alert when a critical hardware-related event occurs. For each PEF, you can choose the action to be taken (or take no action) when a platform event occurs. You can also choose to generate and send an alert when a platform event occurs. Alerts are sent as an SNMP trap, so you must configure an SNMP trap destination before the alerts can be sent.

You can globally enable or disable the generation of platform event alerts. When disabled, alerts are not sent even if PEFs are configured to send them.

Enabling Platform Event Alerts

Procedure

	Command or Action	Purpose
Step 1	Server# scope fault	Enters the fault command mode.
Step 2	Server /fault # set	Enables platform event alerts.
	platform-event-enabled yes

Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5

OL-28893-01 149