3Com MSR 50, MSR 30 manual Default output rules for different output directions, 2441, Nms

2441

Use the undo info-center source command to remove the specified output rules.

By default, the output rules for the system information are listed in Table 633.

This command can be used to filter and redirect system information.

For example, the user can set to output log information with severity higher than warnings to the log host, and information with severity higher than informational to the log buffer. The user can also set to output trap information of the IP module to a specified output direction.

Note that:

■If you do not use the module-nameargument to set output rules for a module, the module uses the default output rules or the output rules set by the default keyword; otherwise the module uses the output rules separately set for it.

■When you use the module-nameargument to separately set the output rules for a module, the default output rules for the module become: Log and trap information is enabled, with severity being informational; debug information is disabled, with severity being debugging.

■After you separately set the output rules for a module, you must use the module-nameargument to modify or remove the rules. The new configuration by using the default keyword is invalid on the module.

Table 633 Default output rules for different output directions

		LOG		TRAP		DEBUG
Output	Modules	Enabled/		Enabled/		Enabled/
direction	allowed	disabled	Severity	disabled	Severity	disabled	Severity
Console	default (all	Enabled	warnings	Enabled	debuggin	Enabled	debuggin
	modules)				g		g
Monitorin	default (all	Enabled	warnings	Enabled	debuggin	Enabled	debuggin
g terminal	modules)				g		g
Log host	default (all	Enabled	informatio	Enabled	debuggin	Disabled	debuggin
	modules)		nal		g		g
Trap	default (all	Disabled	informatio	Enabled	warnings	Disabled	debuggin
buffer	modules)		nal				g
Log buffer	default (all	Enabled	warnings	Disabled	debuggin	Disabled	debuggin
	modules)				g		g
SNMP	default (all	Disabled	debuggin	Enabled	warnings	Disabled	debuggin
NMS	modules)		g				g
Log file	default (all	Enabled	debuggin	Enabled	debuggin	Disabled	debuggin
	modules)		g		g		g

Example # Set the output channel for the log information of VLAN module to snmpagent and to output information with severity being emergencies.

<Sysname> system-view

[Sysname] info-center source vlan channel snmpagent log level emergencies