3Com MSR 30, MSR 50 manual Log-peer-change IS-IS view, Lsp-fragments-extend

1076 CHAPTER 74: IS-IS CONFIGURATION COMMANDS

log-peer-change (IS-IS view)

Syntax	log-peer-change
	undo log-peer-change
View	IS-IS view
Parameters	None
Description	Use the log-peer-changecommand to enable logging on IS-IS adjacency state
	changes.
	Use the undo log-peer-changecommand to disable the logging.
	The feature is enabled by default.
	After the feature is enabled, information about IS-IS adjacency state changes is
	sent to the configuration terminal.
Examples	# Enable logging on the IS-IS adjacency state changes.
	<Sysname> system-view
	[Sysname] isis
	[Sysname-isis-1] log-peer-change

lsp-fragments-extend

Syntax	lsp-fragments-extend [ [ level-1 level-2 level-1-2 ] [ mode-1 mode-2 ] ] *
	undo lsp-fragments-extend
View	IS-IS view
Parameters	mode-1: Fragment extension mode 1, used on a network where some routers do
	not support LSP fragment extension.
	mode-2: Fragment extension mode 2, used on a network where all routers
	support LSP fragment extension.
	level-1:Applies the fragment extension mode to Level-1 LSPs.
	level-2:Applies the fragment extension mode to Level-2 LSPs.
	level-1-2: Applies the fragment extension mode to both Level-1 and Level-2 LSPs.

n The mode-1and level-1-2keywords are used by default.