3Com MSR 50, MSR 30 manual X25 response called-address, X25 response calling-address, 455

455

x25 response called-address

Syntax x25 response called-address

undo x25 response called-address

View Interface view

Parameter None

Description Use the x25 response called-addresscommand to enable X.25 call reception packets to carry the address information of the called DTE.

Use the undo x25 response called-addresscommand to disable the above function.

By default, this function is disabled.

According to X.25, the call reception packet may or may not carry an address code group, depending on the specific network requirements. This command enables users to easily specify whether the packet carries the called DTE address.

Related command: x25 response calling-address,x25 ignore called-address,x25 ignore calling-address.

Example # Specify that the call receiving packet of a call sent from the X.25 interface Serial 2/0 carries the called DTE address.

<Sysname> system-view

[Sysname] interface serial 2/0

[Sysname-Serial2/0] x25 response called-address

x25 response calling-address

Syntax x25 response calling-address

undo x25 response calling-address

View Interface view

Parameter None

Description Use the x25 response calling-addresscommand to enable X.25 to carry the address information of the calling DTE in call reception packets

Use the undo x25 response calling-addresscommand to restore the default.

By default, this function is disabled.