3Com MSR 50, MSR 30 manual X25 switching, Syntax x25 switching Undo x25 switching

	463
Table 71 XOT channel parameter option
Option	Description
timer seconds	Keepalive timer delay of XOT connection. The timer sends the
	keepalive packet upon timeout to detect the connection
	availability. Its value ranges from 1 to 3600.
retry times	Number of maximum retries of sending keepalive. If the number
	exceeds times, the XOT connection will be disconnected. Its value
	ranges from 3 to 3600.
source interface-type	Type and number of the interface that initiates the XOT
interface-number	connection.

Description Use the x25 switch svc xot command to add an X.25 switching route whose forwarding address is XOT channel.

Use the undo x25 switch svc xot command to delete the specified X.25 switching route.

By default, no X.25 switching route is configured.

After configuring the XOT switching command of X.25 SVC, a user can cross IP network from the local X.25 network to implement the interconnection with the remote X.25 network. If a user configures the keepalive attribute, the link detection for XOT will be supported.

Example # Configure a XOT route and forward the packet whose destination X.121 address is 1 to the destination address whose IP address is 10.1.1.1.

<Sysname> system-view

[Sysname] x25 switch svc 1 xot 10.1.1.1

x25 switching

Syntax x25 switching

undo x25 switching

View System view

Parameter None

Description Use the x25 switching command to enable the X.25 switching function.

Use the undo x25 switching command to disable this function, which will not affect the established VC switching.

By default, X.25 packet switching function is disabled.

X.25 packet switching is used to accept packets from an X.25 interface and send them to a certain interface based on the destination information contained in the packets. The device with this function can be used as a small-sized packet switch.