3Com MSR 30 Isdn link-mode, Isdn number-property, Syntax isdn link-mode p2p Undo isdn link-mode

578CHAPTER 37: ISDN CONFIGURATION COMMANDS

Description Use the isdn L3-timercommand to configure the duration of an ISDN protocol L3 timer. Use the undo isdn L3-timercommand to restore the default duration of the ISDN L3 timer on the interface.

You can view the default durations of the L3 timers in the ISDN protocol by executing the display isdn parameters command.

Example # Set the duration of the L3 timer T301 on the interface BRI 1/0 to 160 seconds.

<Sysname> system-view

[Sysname] interface bri 1/0

[Sysname-Bri1/0] isdn l3-timer t301 160

isdn link-mode

Syntax isdn link-mode p2p

undo isdn link-mode

View ISDN BRI interface

Parameter None

Description Use the isdn link-mode p2p command to configure a BRI interface to operate in the point-to-point mode.

Use the undo isdn link-modecommand to restore the default BRI interface operating mode.

By default, a BRI interface operates in the point-to-multipoint mode, in which a BRI interface operating on the network side can have multiple end devices attached to it.

Example # Configure BRI1/0 interface to operate in the point-to-point mode.

<Sysname> system-view

[Sysname] interface bri 1/0

[Sysname-Bri1/0] isdn link-mode p2p

isdn number-property

Syntax isdn number-property number-property[ calling called ] [ in out ]

undo isdn number-property [ calling called ] [ in out ]

View ISDN interface view

Parameter number-property: Type and number scheme of ISDN numbers. The argument takes on a hex value in the range of 0 to 7F. When it is expressed in 8 bits, bits 1 through 4 represent the code scheme, bits 5 through 7 represent the code type, and bit 8 is