3Com MSR 30, MSR 50 manual Port Isolation Configuration Commands

654CHAPTER 42: PORT ISOLATION CONFIGURATION COMMANDS

Description Use the port-isolate enable command to add the current port to the default isolation group (Group 1) as an ordinary port.

Use the undo port-isolate enable command to remove the port from the isolation group.

Configured in Ethernet interface view, the setting is effective on the current port only; configured in port group view, the setting is effective on all ports in the port group.

Refer to “Link Aggregation Configuration Commands” on page 473 for information about port groups.

This command adds a port to the default isolation group 1.

Example # Add port Ethernet 1/0 to isolation group 1.

<Sysname> system-view

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0] port-isolate enable