3Com MSR 50, MSR 30 manual Sendring ringbusy enable, Related command cas and trunk-direction, 2667

2667

min: Selects the timeslot with the smallest number from currently available timeslots.

minpoll: Selects the timeslot with the lowest number from available timeslots in the first timeslot polling; in later pollings, selects in ascending order timeslots with numbers greater than the one picked out in the previous polling. Suppose TS1 and TS3 are not available. In the first polling, TS2 will be picked out for use and in the next polling, TS4.

Description Use the select-modecommand to set the E1 trunk routing mode.

Use the undo select-modecommand to restore the default.

By default, the timeslot with the smallest number is selected.

Related command: cas and trunk-direction.

Example # Set the trunk routing mode for TS group 5 to max on interface E1 1/0.

<Sysname> system-view [Sysname] controller e1 1/0

[Sysname-e1 1/0] timeslot-set 5 timeslot-list 1-31 signal r2 [Sysname-e1 1/0] cas 5

[Sysname-cas1/0:5] select-mode max

sendring ringbusy enable

Syntax sendring ringbusy enable

undo sendring ringbusy enable

View R2 CAS view

Parameter None

Description Use the sendring ringbusy enable command to enable the terminating point to send busy tones to calling subscribers.

Use the undo sendring ringbusy enable command to disable the terminating point from sending busy tones to calling subscribers.

By default, the terminating point sends busy tones to calling subscribers.

This command applies to R2 signaling only.

Related command: timer ring.

Example # On TS group 5 on interface E1 1/0 configure the terminating point to send ringback tone to the calling side.