3Com MSR 50, MSR 30 manual Static-cr-lsp transit, CR-LSP on the ingress or a transit node

1641

Description	Use the static-cr-lsp ingress command to configure a static CR-LSP at the
	ingress node.
	Use the undo static-cr-lsp ingress command to remove the static CR-LSP.
n	The next hop address cannot be a local public address when configuring the static
	CR-LSP on the ingress or a transit node.
Example	# Configure a static CR-LSP on the ingress node, setting its name to Tunnel3,
	destination IP address to 202.25.38.1, destination address mask length to 24, next
	hop IP address to 202.55.25.33, outgoing label to 237, and required bandwidth
	to 20 kbps.
	<Sysname> system-view
	[Sysname] static-cr-lsp ingress Tunnel3 destination 202.25.38.1 next
	hop 202.55.25.33 out-label 237 bandwidth 20
static-cr-lsp transit
Syntax	static-cr-lsp transit tunnel-name incoming-interfaceinterface-type interface-number
	in-labelin-label-value { nexthop next-hop-addr outgoing-interfaceinterface-type
	interface-number } out-labelout-label-value [ bandwidth [ bc0 bc1 ]
	bandwidth-value ]
	undo static-cr-lsp transit tunnel-name
View	System view
Parameter	Tunnel-name: Tunnel name comprising 1 to 15 characters.
	next-hop-addr: Next hop address.
	outgoing-interfaceinterface-type interface-number: Specifies an outgoing
	interface for the static CR-LSP.
	in-label-value: Incoming label, in the range 16 to 1023.
	out-label-value: Outgoing label, in the range 16 to 1023.
	bc0: Obtains bandwidth from a subpool.
	bc1: Obtains bandwidth from the global pool.
	bandwidth-value: Bandwidth assigned to the CR-LSP, in the range 1 to 32000000
	kbps.
Description	Use the static-cr-lsp transit command to configure a static CR-LSP on a transit
	node.
	Use the undo static-cr-lsp transit command to remove the static CR-LSP.