3Com MSR 50 Reset dot1x statistics, Example # Set the server timeout timer to 150 seconds, 1911

1911

response after sending the allowed maximum number of handshake requests, it considers that the supplicant is offline.

■Quiet timer (quiet-period): When a supplicant fails the authentication, the authenticator refuses further authentication requests from the supplicant in this period of time.

■Server timeout timer (server-timeout): Once an authenticator sends a RADIUS Access-Request packet to the authentication server, it starts this timer. If this timer expires but it receives no response from the server, it retransmits the request.

■Supplicant timeout timer (supp-timeout): Once an authenticator sends an EAP-Request/MD5 Challenge frame to a supplicant, it starts this timer. If this timer expires but it receives no response from the supplicant, it retransmits the request.

■Username request timeout timer (tx-period): Once an authenticator sends an EAP-Request/Identity frame to a supplicant, it starts this timer. If this timer expires but it receives no response from the supplicant, it retransmits the request. In addition, to be compatible with clients that do not send EAPOL-Start requests unsolicitedly, the device multicasts EAP-Request/Identity frame periodically to detect the clients, with the multicast interval defined by tx-period.

Generally, it is unnecessary to change the timers unless in some special or extreme network environments.

Related command: display dot1x.

Example # Set the server timeout timer to 150 seconds.

<Sysname> system-view

[Sysname] dot1x timer server-timeout 150

reset dot1x statistics

Syntax	reset dot1x statistics [ interface interface-list]
View	User view
Parameter	interface interface-list: Specifies an Ethernet port list, which can contain multiple
	Ethernet ports. The interface-listargument is in the format of interface-list=
	{ interface-type interface-number [ to interface-type interface-number ] } &
	<1-10>, where interface-typerepresents the port type, interface-number
	represents the port number, and & <1-10> means that you can provide up to 10
	port indexes/port index lists for this argument. The start port number must be
	smaller than the end number and the two ports must of the same type.

Description Use the reset dot1x statistics command to clear 802.1x statistics.