Dell 9.7(0.0) manual Command History Example Related Commands, Parameters Delay-restore

Command History

Example

Related Commands

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.5(0.0)	Introduced on the Z9500.
9.2(0.0)	Introduced on the M I/O Aggregator. This command is
	supported in Programmable-Mux (PMUX) mode only.
9.2(0.2)	Added multicast and ndp parameters.

9.0.2.0Introduced on the S6000.

9.0.0.0Introduced on the Z9000.

8.3.19.0Introduced on the S4820T.

8.3.12.0Introduced on the S4810.

VLT ARP Statistics

----------------

ARP Tunnel Pkts sent:0 ARP Tunnel Pkts Rcvd:0 ARP-sync Pkts Sent:0 ARP-sync Pkts Rcvd:0 ARP Reg Request sent:19 ARP Reg Request rcvd:10

show vlt statistics — displays statistics on VLT operations.

delay-restore

Configure the delay in bringing up VLT ports after reload or peer-link restoration between the VLT peer switches.

Syntax	delay-restore
Parameters	delay-restore	Enter the amount of time, in seconds, to delay bringing up
		the VLT ports after the VLTi device is reloaded or after the
		peer-link is restored between VLT peer switches. The range
		from 1 to 1200. The default is 90 seconds.
Defaults	Not configured.
Command	VLT DOMAIN
Modes

1628 Virtual Link Trunking (VLT)